3RLSQ8033SW0 Whirlpool Washer - Parts

Oil Seal Kit for Gearcase Input Shaft This two piece oil seal kit comes in two pieces and is used for the gearcase input shaft of your washer. Add to cart

Hose Clamp Note: This part has been updated by the manufacturer. It may appear different but will still function the same as the original. Add to cart

Spring Outer Bracket Sold individually. Add to cart

Lid Bumper This gray and white washer lid bumper contains a rubber bottom and is sold individually. Add to cart

Bottom Agitator

★★★★★

★★★★★

(2)

This is only the base, or the lower half of the agitator. Add to cart

Spin Tube Bearing

★★★★★

★★★★★

(1)

This spin tube T-Bearing is an inch long. Sold individually. Add to cart

Spanner Nut Right hand threaded nut holds the tub in place in direct drive, top loading washing machines. To remove the spanner nut you will need a spanner wrench. Add to cart

Water Inlet Hose Washer Sold Individually. Order quantity needed. Add to cart

Cabinet Retaining Clip CLIP-TOP&CAB-R PNL Add to cart

Water Level Switch This water level switch senses the level of water in the inner tub. Add to cart

Water Pressure Hose - Cut-to-Fit

★★★★★

★★★★★

(2)

This is the hose that tells your appliance if your tub is at the desired water level. Add to cart

Centerpost Bearing and Seal Assembly This assembly comes with one transmission stem seal, two center post bearings, and three agitator shaft seals. Add to cart