3LBR5132AW0 Whirlpool Washer - Parts

This part is used to activate the lid switch when the lid opens/closes.

This hose can handle hot or cold water and is five feet long.

This part prevents the agitator shaft from leaking oil onto the transmission.

The neutral drain kit prevents the basket from spinning during the drain cycle.

Sold individually. NOTE: The color on the screw may not be the same as the image, but will still function the same.

This part gets the motor up to speed quickly before transferring power to the run capacitor.

This part is the replacement water inlet hose for your washer. It is black in color, made of plastic, and is approximately 19 inches long. The water inlet hose connects the water inlet valve to the water fill nozzle. Over time the hose can become cracked and damaged, and this can cause it to leak. A damaged hose will need to be replaced. ...Read moreBe sure to disconnect the water supply to the washer before you begin this repair. You should also determine if any of the other parts that transport water into the washer are leaking, and if they need to be repaired as well. This part is sold individually and is a genuine OEM part.

Used to drain water.

Sold individually.

This spin tube T-Bearing is an inch long. Sold individually.

This gray and white washer lid bumper contains a rubber bottom and is sold individually.

This two piece oil seal kit comes in two pieces and is used for the gearcase input shaft of your washer.