3660 (Type 1) Black and Decker Miter Saw - Parts

This is a genuine Dewalt replacement bearing sleeve. It houses a ball bearing for secure seating in many Dewalt power tools. It is compatible with the Dewalt tools listed in the 'Compatibility' section below, but it is not guaranteed to fit any other bearings or power tools.

It is a genuine manufacturer sourced replacement part designed for use with a variety of power tools. It is a standard screw that has multiple uses based on a tool. To ensure compatibility please make sure to check appropriate diagrams for correct location and use of this item. Includes one (1) metal screw per order. Requires a screwdriver for installation/removal.

This replacement screw is an authentic manufacturer sourced item. It is commonly used with a variety of power tools. This screw is a standard hardware which has multiple uses based on equipment. To ensure correct location and application of this item please make sure to check appropriate diagrams. It is made out of metal and it is sold in...Read moredividually. Requires a torx or a flat-head screwdriver to tighten/loosen this screw.

This genuine OEM replacement part is crafted from durable metal and designed to fit a wide range of power tools, making it a versatile solution for various repair needs. Whether you're replacing a worn-out component or upgrading your tool's performance, this part ensures reliable functionality. Please note that it is sold individually, so...Read more be sure to check your tool’s requirements before ordering. Installation is straightforward but requires a Torx screwdriver to properly tighten or loosen the screw. Always refer to your tool’s manual for specific installation guidance to ensure a secure fit.

It is an authentic OEM supplied replacement hardware that is specially produced for use with Dewalt and Black and Decker power tools. This special screw has multiple applications depending on the model of your unit, please make sure to check appropriate diagrams for correct application of this item. This durable metal Torx screw is sold individually.

Genuine DeWalt replacement part. This torx button-head screw is sold individually.

This is an authentic Craftsman replacement part, sourced from the original manufacturer for use with circular saws and hammer drills. The special retaining ring is commonly used to secure the fan to the armature's shaft. This item is available as an individual replacement part, please see illustrated diagram for associative parts.

It is a genuine hardware that is supplied directly from original equipment manufacturer for use with Dewalt and Black and Decker power tools. This replacement screw is used to secure the field case. Please note this durable metal Torx screw is sold individually.

O-rings are designed to contain thousands of pounds of pressure by creating a seal between two or more parts. O-ring measurements are defined by the inside diameter and the thickness. There are many causes for O-Ring failure, such as pressure, friction, temperature or chemicals. The most common are: • Extrusion and Nibbling...Read moreu> - O-ring has ragged, tattered edges. These are commonly caused by pressure spikes which shear off tiny "bites" from the o-ring, or caused by clearance gaps. • Abrasion - One or both sides of the o-ring appear rough and slightly flattened. Commonly caused by a contact surface that is too rough, contains grit or is too smooth to allow lubrication. • Over Compression - O-ring is flattened on both sides and may have a "ring" split along its length. Commonly caused by excessive pressure or heat. • Heat Hardening - O-ring has a pitted or cracked surface, and often is flattened on both sides. Caused by temperature exceeding o-ring capacity. • Weather/Ozone Cracking - O-ring is covered in small surface cracks. Caused by exposure to ozone, UV rays and air pollution. Excessive seal stretching causes similar cracking.

Read less