Models > 36368285893 > Instructions

36368285893 Kenmore Refrigerator - Instructions

All Instructions for the 36368285893
121 - 133 of 133
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Freezer worked, frig not cooling
First, read through blogs which said it could be something frozen up. I unplugged and let it warm for a few days. Didn't work. No ice found. Then, assumed to be thermostat. Unplug frig. One screw removes cover, then another 2 screws to take out thermostat compartment. Unplug wires from harness and remove. Simply put in the new thermo (reverse from removal), and reassemble. Bingo, nice and cool within 12 hr. Rock solid 35F ever since. Pretty simple.
Parts Used:
Thermostat Control
  • James from Columbia, MO
  • Difficulty Level:
    Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Nutdriver
Was this instruction helpful to you?
Thank you for voting!
broken rail
Just follow instructions
Parts Used:
Vegetable Drawer Slide Rail - Left Side Vegetable Drawer Slide Rail - Right Side
  • leonard from albany, GA
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Screw drivers
Was this instruction helpful to you?
Thank you for voting!
Broken meat drawer side rail
The hardest part was figuring out the part needed from so many little pictures. The actual repair, a piece of cake!
Parts Used:
Drawer Slide Rail - Right Side
  • Ann from Hanover, NH
  • Difficulty Level:
    Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Screw drivers
Was this instruction helpful to you?
Thank you for voting!
Freezer door shelf Retainer bar end cap broke.
Easy!!!! No tools required and just had to lift the bar and pull it away from the door. Unsnap the end cap snap the new one on and place the connecter back into the slot on the freezer door and voila!!!!!!
Parts Used:
Door Shelf Retainer Bar End Cap - Right Side
  • Carol from Hull, MA
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
The Front bar was torn from the Slides and drawers were broken.
Placed slide assembly on table and followed the steps shown on your video.Thanks
Parts Used:
Lower Crisper Drawer Center Cover Slide Drawer Slide Gasket
  • Howard from Silver Spring, MD
  • Difficulty Level:
    Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Screw drivers
Was this instruction helpful to you?
Thank you for voting!
The rails on vegetable drawers and the meat drawer were broken off .
I watched and followed the instructions given in the video. The refrigerator almost looks new!
Parts Used:
Drawer Slide Rail - Left Side Drawer Slide Rail - Right Side Vegetable Drawer Slide Rail - Left Side
  • Barbara from Lynchburg, VA
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Screw drivers
Was this instruction helpful to you?
Thank you for voting!
left side rail broke in half middle support broke at front end
As instructed actually my wife ordered the parts and
Installed herself. Positive experience.
Parts Used:
Vegetable Drawer Slide Rail - Left Side Center Cover Slide
  • JOE from INDIAN ROCKS BEACH, FL
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Nutdriver
Was this instruction helpful to you?
Thank you for voting!
failed light switch
I started removing the switch by prying on the right side with a screwdriver, when it emerged enough I used pliers to finish removing it. I then unpluged rhe wires from the bad switch and pluged them on the new switch and "poped" it into the hole.
Parts Used:
Light Switch
  • Jules from Crowley, LA
  • Difficulty Level:
    Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Pliers, Screw drivers
Was this instruction helpful to you?
Thank you for voting!
no light in freezer
Connected the 2 wires and pushed in the switch until it clicked.
Parts Used:
Light Switch
  • christopher from collegeville, PA
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
refig light did not work
per your instructions
Parts Used:
Light Switch
  • paul from east hanover, NJ
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Pliers, Screw drivers
Was this instruction helpful to you?
Thank you for voting!
broken slide rail replaced both sides
took out two screws both sides useing philips head screw driver put back same way
Parts Used:
Drawer Slide Rail - Left Side Drawer Slide Rail - Right Side
  • William from Manchester, NJ
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Screw drivers
Was this instruction helpful to you?
Thank you for voting!
Noisy fan
Emptied freezes, turned off power, took floor of freezer out [4 screws ], took two screws out of fan mounts and replaces fan. Reassembled by reverse process. Simple
Parts Used:
Evaporator Fan Blade Kit
  • Robert L. from Eldred, PA
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Screw drivers
Was this instruction helpful to you?
Thank you for voting!
switch wouldn't come out anymore and turn light on
Gently pry out switch in door jam with screwdriver and pull both connectors off and put connectors on new switch then push switch back into the hole. Looked it up on the internet and video showed how to and also had link to new part, ordered and less than a week later the fridge is bright again. I have an older freezer also and it seems that they all use the same switches. Very Very easy
Parts Used:
Light Switch
  • Cynthia from Seatac, WA
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Screw drivers
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the 36368285893
121 - 133 of 133
Back to Top