36315672000 Kenmore Dishwasher - Parts
Enter a part description. DIY Heroes keep it simple, eg. "belt" or "pump".
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Rinse Aid Fill Cap
Part #WD12X10284
This part helps keep the rinse aid the dispenser until its needed.
Water Inlet Valve
Part #WD15X10003
This water inlet valve should be located behind the lower kickplate panel in either the right or left corner. The attaching solenoids on the valve open and close according to the desired amount of water needed. This valve has a 3/8" inlet and comes with the mounting bracket.
Upper Spray Arm Water Supply Hose
Part #WD24X214
This is the replacement upper spray arm water supply hose for dishwasher. It is made of white plastic and has a connector piece on each end. This hose supplies water to the upper spray arm, so it can be sprayed onto your dishes when the dishwasher is running. The main reason to replace the supply hose is if it is cracked and leaking, and ...Read morethe spray arm is not getting enough water. This part is sold individually and is a genuine OEM part sourced directly from the manufacturer.
Read less
Drain Solenoid and Bracket Assembly
Part #WD21X10268
This valve opens in order for the water to drain out of the dishwasher.
Lower Spray Arm with Tower
Part #WD22X155
This part may differ in appearance, but functions same as original.
Sump Housing
Part #WD18X213
This part is the replacement sump housing or sump insert for your dishwasher. It is made of plastic and is approximately 7 inches by 5 inches. The sump housing is attached to the bottom of the dishwasher tub and collects water for the pump. If your dishwasher is leaking, you may need to replace the sump housing. Be sure to disconnect the ...Read moredishwasher from the water and power source before you begin this repair. This part is sold individually and is an authentic OEM part sourced directly from the manufacturer.
Read less
Impeller and Seal Kit
Part #WD19X10032
This part helps stop your dishwasher from leaking. This kit includes the impeller, seal, blade, filter, skidder and skidder holder.
Motor and Pump Kit
Part #WD26X10013
This pump and motor kit replaces many old style pump and motor kits that were manufactured since 1970. The instructions are included with this kit to help you to make it adaptable to your dishwasher.
NOTE: This is a completely redesigned kit by the manufacturer and now includes the drain solenoid.
Rinse Aid Injector Container With Gasket
Part #WD35X10346
This part attaches to the inner door panel.