36-R53L575-BC50 (Type 1) Delta Tile Saw - Parts

This is an authentic replacement part manufactured for use with Delta arbor saws and table saws. The load spring is commonly used to provide spacing between the arbor bearing and the arbor flange. This load spring is available as an individual replacement part, please see model diagram for associative parts.

This is a genuine Delta replacement part that is OEM sourced to ensure a high level of quality. The metal screw is intended to be used with table saws and unisaws. The set screw is used to secure both the arbor and motor pulleys. This item is sold as an individual replacement part.

This kick back finger is an authentic replacement part which is manufactured for use with DeWalt table saws. The special anti-kickback device is one of three safety attachments made available for these types of table saws. This anti-kickback along with the blade guard and the riving knife makes operating the saw safer. This device is used...Read more to prevent the material from being shot toward the user in the event of kickback. It is a high-quality item which is made of durable metal and is sold as an individual component. Check the owners manual and the diagrams of your model for the correct installation. You will need a wrench set to perform this repair.

This replacement belt is specially designed for Delta table saws. It is a genuine OEM part, not an aftermarket imitation. This is the main belt that helps to spin the saw blade. Make sure to clean drive pulleys before installing the new belt. This will help to ensure top performance with your new belt. Inspect this belt periodically and r...Read moreeplace it when worn or stretched. This part is made out of durable rubber and it is sold in a pack of three.

This cap screw is a genuine Delta replacement part that is supplied from original equipment manufacturer for use with power equipment. It is a standard hardware which has multiple uses depending on your model, please make sure to check appropriate diagrams for correct use and location of this hardware. Note this durable metal cap screw is sold individually.

This see thru guard is supplied from original manufacturer for use with Delta saws. This part helps to direct dust and trimmings away from the user. This will help to keep the work area clean as well as provide protection from the blade while unit is in operation. It is made out of clear plastic and it is sold individually. Please note th...Read moree hardware and bracket are both sold separately. To replace this guard you would need pliers.

The pivot bracket attaches to the see thru guard. This item is available as an individual replacement part. This is a genuine replacement part sourced from the original manufacturer for use with table saws made by Delta. A set of pliers may be necessary during the installation of this item. It is made of metal and will need to be replaced if it breaks.

This high-quality spring is designed for use with Delta saws. It is supplied by the original equipment manufacturer. The spring applies tension on the kickback finger allowing it to retract. Over time it may wear out and lose tension eventually requiring a replacement. It is made of high-quality metal and is sold as an individual componen...Read moret. Make sure to check the diagrams of your model for the exact location and the correct installation of this spring. You will need a screwdriver to remove the push pin that holds the old spring.