340K (Type 1) Porter Cable Orbital or Palm Sander - Parts

This cord protector is a genuine Porter Cable replacement part and is sold individually. Cord Protectors are designed to slide onto your cord and fit securely at the end, where it's firm rubber will protect the base of the cord from getting bent and pinched. Which can expose the wires and become a safety hazard.

This is a Ball Bearing that is sealed on both sides. This is a genuine Porter Cable replacement part that is sold individually. • Ball bearings minimize friction between 2 parts in your tool that would otherwise spin and rub against each other. The balls or rollers take the load and spin, distributing the weight evenly while the mini...Read moremal contact area of the balls reduce friction. This reduces wear on the tool and allows it to run smoothly. • Bearings experience constant wear when the tool is in operation from pressure, heat, vibration and friction. Because of this, many Bearings need periodic maintenance or replacement.

This is a genuine replacement part sourced directly from the manufacturer. The seal is commonly found in sanders from Porter Cable and Black & Decker. This part is made of flexible rubber, and is used to seal the connection with the rubber sander pad. You will require a screwdriver when replacing this item. The seal is sold as an individual replacement part.

This is a Ball Bearing that is sealed on both sides. This genuine Porter Cable replacement part is sold individually. • Ball bearings minimize friction between rotating parts in your tool. The balls or rollers bear the load and spin, distributing the weight evenly, while the minimal contact area of the balls reduces friction. This red...Read moreuces wear on the tool, allowing it to run smoothly. • Bearings experience constant wear when the tool is in operation from pressure, heat, vibration and friction. Because of this, many Bearings need periodic maintenance or replacement.

This is a Genuine OEM replacement part used on a variety of Power Tools. It allows to keep the Carrying Case closed. This part is made out of Plastic and it is Sold Individually. Included in part number 901023

It is a genuine manufacturer-approved switch which is specially made for Porter Cable and Black and Decker sanders. It is the part of the tool handling on/off operations. Unfortunately, over time components will wear out and it may begin to fail eventually requiring a replacement. Make sure to refer to the appropriate diagrams of your mod...Read moreel for the correct location and application of this switch. Keep in mind it has a durable plastic body and is sold individually. NOTE: This is a 220/230 Volt switch for the Porter-Cable models listed below. It will not work with 120V tools. The 120V switch is available here Switch (120V) 875276.