34-466 Delta Miter Saw - Parts

This set screw is a genuine OEM sourced replacement part. It is commonly used on a variety of Delta and Porter Cable power tools. A set screw is used to secure an object within or against another object. Please make sure to check appropriate diagrams for correct location and use of this set screw. You will need a hex key/allen wrench to install or remove this item.

This is an authentic Delta replacement part, sourced from the original manufacturer for use with table saws, air cleaners, lathes, industrial shapers, and radial arm saws. The metal screw is used with several different types of machines and the application of the screw can vary based on the model of the equipment. This item is available as an individual replacement part.

This is an authentic manufacturer-supplied part which is specially made for Delta equipment. It is one of the special screws utilized to secure the nameplate. Please refer to appropriate diagrams of your model for the exact location and use of this hardware. This high-quality drive screw is made of durable metal and is sold individually. ...Read moreNote, the screw is installed into a pre-drilled hole. You will need a hammer to secure this component.

This special nut is priced individually and fits next to the lock washer. It is made out of metal and will need to be replaced if it becomes stripped or broken. A wrench will be needed during the installation of this part. The nut is an authentic part from Delta to be used in drill presses.

Genuine Delta replacement part, this item is sold individually. The purpose of the is nut is to secure the blade of the Table Saw to the Saw Arbor. It is a left hand ACME thread. It is used on all of the right tilting Table Saws listed below.

This part is sold individually. The hex nut attaches to the rear trunnion. A wrench may be required to replace this item. It is made of metal and will require replacing if it strips or breaks. This part is an OEM sourced directly from the manufacturer for use in Delta sanders and saws.

This is a genuine manufacturer sourced replacement part used on Delta and Black and Decker equipment. It helps to distribute the pressure evenly and provide a tight seal between connected components. This is a standard hardware which may have multiple applications. For the exact location please refer to the diagrams of your specific model. This part is made of high-quality metal and is sold individually.