3315 (Type 2) Black and Decker Router - Parts

The screw attaches to the sub base and is made of metal. This item is available individually. This part is an OEM from DeWALT and Black & Decker for use in engines and routers. During replacement, it may require a flathead screwdriver to help install this item correctly. It will require replacing if it becomes stripped or broken.

This replacement 1/4 collet is specially designed for use with Dewalt and Black and Decker die grinders and routers. It is a high-quality component which is supplied directly from the original equipment manufacturer and it is sold individually. This part provides a stable grip for securing a bit in a tool. Please note this durable metal c...Read moreollet is for using bits with 1/4" arbors only, keep in mind the collet nut is sold separately.

This is a genuine DeWalt replacement part that is sourced from the original manufacturer for use with routers. The sealed ball bearing is used to reduce friction between the rotating armature and the fixed housing assembly. The bearing is available as an individual replacement part.

This is a genuine item that is supplied directly from the original equipment manufacturer for use with DeWALT and Black and Decker power tools. The purpose of a bearing is to allow connected parts to rotate with minimum friction, unfortunately, over time components will wear out and may begin to fail eventually requiring a replacement. It...Read more is an identical replacement for a missing or a faulty bearing that was installed on a new unit, please make sure to check the diagrams of your model for the correct location and application of this hardware. Keep in mind this high-quality component is made of durable metal and is sold individually.

This is a genuine replacement part sourced directly from the manufacturer. The screw is commonly found in routers from DeWALT and Black & Decker. This part is made of metal, and is generally used to secure the knob to the base. Please be aware that there are different screws used in the machine. Refer to the parts diagram to be sure o...Read moref ordering the correct part. You may require a screwdriver or Allen wrench when replacing this item. The screw is sold as an individual replacement part.

Genuine Dewalt/Black & Decker replacement part. includes 1 Carbon Brush with wire lead and brush spring attached. 2 Brushes are needed for the tools listed below. • Worn brushes are often the cause of a poorly running motor • Replacing brushes can fix an intermittent motor • New brushes can restore a motor's electric braking Carb...Read moreon motor brushes are one of the most commonly replaced power tool components. Because carbon brushes are wear items, meaning that through friction and use they will gradually wear away, they will eventually require replacement. Worn brushes are common causes of intermittent motor function, reduced electric braking, and reduced motor power. A worn out brush will often be worn down near the wire lead and may be cracked, pitted, or burned. When replacing carbon brushes, be sure to also inspect your armature for burns, cracks, or other damage which indicates a larger motor problem.

It is a genuine manufacturer-sourced replacement part that is supplied for use with DeWALT and Black and Decker power tools. This is a special o-ring which is utilized to provide an air-tight seal between connected pieces, for the correct application make sure to check appropriate diagram of your model. Over time o-rings tend to deteriora...Read morete and crack eventually requiring a replacement to maintain the proper seal. It is a high-quality component which is made of durable rubber material and is sold individually.