3037-09 Black and Decker Circular Saw - Overview

This is a genuine DeWalt replacement part that is sourced from the original manufacturer to be used with various types of equipment. The metal washer is commonly used to provide spacing and to disperse pressure put on a part assembly across a wider surface area. This item is available as an individual replacement part.

This extension spring is sourced directly from the original equipment manufacturer for Black and Decker and DeWALT drill presses. It is an important component that applies tension on the knob for the edge guide. Over time it may wear out and lose tension eventually requiring a replacement. To ensure the correct installation of this hardwa...Read morere, check the diagrams of your specific model. This high-quality spring is made of a durable metal and is sold as an individual item. Replacing it does not require any tools, remove the knob and replace the spring.

This part is an OEM genuine replacement plug for Craftsman tools. The housing of this plug is made of a high quality durable material. It comes complete with neutral, hot and ground prongs, in order to make a safe and complete circuit. The connecting screws do come with this part, however the tools needed for replacing this part may vary....Read more Please see our repair forum for instructional videos to aid in the replacement of this part.

This is an authentic replacement part sourced directly from the manufacturer. The O-ring is commonly found in power tools such as table saws, reciprocating saws, and impact wrenches from DeWALT and Black & Decker. This part is made of flexible rubber, and may be found in various locations in the machine, depending on model. Please be a...Read moreware that there are different O-rings used in the machine. Refer to the parts diagram to be sure of ordering the correct part. This item is available as an individual replacement part.

The terminal is made out of metal. This item is available as an individual replacement part. It is a genuine DeWALT, Black & Decker, and Porter Cable part sourced directly from the manufacturer for use in saws, drills, engines, grinders, nibblers, routers, sanders, and shears. A set of pliers may be required to replace this item. This part may become broken and will need to be replaced.

O-rings are designed to contain thousands of pounds of pressure by creating a seal between two or more parts. O-ring measurements are defined by the inside diameter and the thickness. There are many causes for O-Ring failure, such as pressure, friction, temperature or chemicals. The most common are: • Extrusion and Nibbling...Read moreu> - O-ring has ragged, tattered edges. These are commonly caused by pressure spikes which shear off tiny "bites" from the o-ring, or caused by clearance gaps. • Abrasion - One or both sides of the o-ring appear rough and slightly flattened. Commonly caused by a contact surface that is too rough, contains grit or is too smooth to allow lubrication. • Over Compression - O-ring is flattened on both sides and may have a "ring" split along its length. Commonly caused by excessive pressure or heat. • Heat Hardening - O-ring has a pitted or cracked surface, and often is flattened on both sides. Caused by temperature exceeding o-ring capacity. • Weather/Ozone Cracking - O-ring is covered in small surface cracks. Caused by exposure to ozone, UV rays and air pollution. Excessive seal stretching causes similar cracking.

Read less