289- Black and Decker Reciprocating Saw - Parts

This is an authentic OEM component from DeWalt. The ring is made for use with many jigsaw devices. The metal ring helps to secure the bell crank components, and is sold individually. Needle nose pliers are often used for the removal and installation.

It is a genuine manufacturer sourced replacement part designed for use with a variety of power tools. It is a standard screw that has multiple uses based on a tool. To ensure compatibility please make sure to check appropriate diagrams for correct location and use of this item. Includes one (1) metal screw per order. Requires a screwdriver for installation/removal.

This is an authentic replacement part manufactured for use with DeWalt, and Black and Decker power tools. Carbon brushes are considered a wear item because they are in constant contact with the spinning armature. Worn brushes can cause a lower level or performance, or cause the power tool to stop working altogether. Most power tools with ...Read morea good amount of use will require the brushes to be replaced at some point. These brushes will come in a pair, and the pair is sold individually.

This is a genuine DeWalt replacement power cord, specifically designed for use with double-insulated tools. Built for durability and safety, it features two wires and two prongs, eliminating the need for a ground wire. The cord measures 8 feet in length and uses 18-gauge wiring, offering a reliable connection and flexible reach for your p...Read moreower tool needs. It’s sold individually and is compatible with the models listed below. Installation requires careful attention: the new cord wires must be properly inserted into the wire terminals, and the cord should be routed correctly to avoid pinching when reassembling the tool’s case or plate. For best results, refer to your tool’s manual or consult a professional technician.

This is an authentic DeWALT and Black & Decker replacement part that is sourced from the original manufacturer for use with saws, grinders, jointers, nibblers, plate joiners, polishers, routers, sanders, and shears. The retaining ring attaches to the ball bearing and is made of metal. When replacing this item an allen wrench and a screwdr...Read moreiver might be required during the installation process. It will need to be replaced if it becomes bent or broken. This part is available as an individual replacement.

This is an original replacement part manufactured for use with electric power tools. The special sleeve is commonly used to provide spacing between the armature bearing and the motor housing. This sleeve is available as an individual replacement part, please see model diagram for associative parts.

This is an authentic replacement part manufactured for use with jigsaws. The special yoke bar is commonly used to link the blade clamp and the main or drive gear. This yoke bar is available as an individual replacement part, please see model diagram for associative parts.

This replacement item is an authentic OEM sourced hardware that is specially produced for Dewalt and Black and Decker jig saws. This set screw is an important piece of blade clamp mechanism that secures the blade, for correct location and use of this hardware please make sure to check appropriate diagrams of your equipment. One durable metal hex socket head set screw is included per order.

This is a genuine OEM replacement part, it is sold individually. This part is used to keep the brush tight against the armature so the tool will work properly. Over time when the brushes wear down and heat is created, the spring may lose its tension and will have to be replaced.