2802K (Type 1) DeWALT Screwdriver - Parts

Includes part numbers 330003-04, 93128-00, 696631-00, 94518-00

Included in part number 380264-09

This is an authentic DeWALT replacement part. The spring is commonly found in DeWALT power tools such as drills and screwdrivers. This is a metal part used to hold the shifter switch in place. This part is sold individually.

It is a genuine item that is supplied directly from the original equipment manufacturer for use with DeWALT and Black and Decker screwdrivers. This special component is utilized to provide an air-tight seal between connected parts, please make sure to refer to the appropriate diagrams of your model for the correct location and application...Read more of this hardware. Keep in mind over time the material may wear out and crack eventually requiring a replacement. It is a high-quality seal which is made of durable material is sold individually.

Genuine Dewalt replacement part, this item is sold individually. The 696631-00 Steel Ball is part of the chuck assembly of the Impact Drivers shown below. When you pull back the sleeve of the chuck assembly and insert your bit, the Steel Ball is the part that locks the bit in the chuck assembly. In the Screw Drivers listed below this is the part that secures the Bit Holder in the spindle.

This is a genuine manufacturer-approved component which is designed for use with DeWALT and Black and Decker screwdrivers. The purpose of a spring is to apply tension on the guide in the clutch. Unfortunately, over time it may wear out, get damaged or simply lost eventually requiring a replacement. To ensure the exact location and the cor...Read morerect application of this hardware, refer to the diagrams of your model. One durable metal spring is included.

This synthetic gear grease is used to lubricate internal gears in power tools, reducing friction, wear, and noise during operation. Its high-performance formula helps prevent corrosion and protects moving parts under load. Applying fresh grease during maintenance restores smooth gear movement and extends tool life.

This brush kit is supplied directly from original equipment manufacturer. It is a genuine replacement item that is specially designed for use with drills/drivers. Carbon brushes are some of the most commonly replaced items. Due to normal use and friction brushes will gradually wear down requiring replacement. It is advised to replace both...Read more brushes at the same type. This set includes two (2) carbon brushes, two (2) metal brush holders with springs and two (2) lead wires. You would need a screwdriver to complete this job. • Make sure the unit is unplugged • Remove the housing screws • Separate the housing halves • Disconnect lead wires • Take out old brushes and replace them with the new ones • Reassemble and test the tool

This is a genuine OEM sourced replacement part used on screwdrivers. The plastic locator is fasted onto the cap and adj. collar in the nose piece. This item helps to secure the bit tip holder. A screwdriver is needed in making the repair. The locator is sold individually, but is also included in the nosepiece (450147-01).

This item is a genuine DeWalt replacement part that is intended to be used with cordless drills and drivers. The bit clip can be used as a direct replacement of the original clip that would have been installed on a new drill. The clip snaps onto the side of drill's housing and is used to store frequently used drill bits. This item is priced as a single replacement part.

This is a genuine DeWalt replacement part that is sourced from the original manufacturer for use with electric screwdrivers. The collar adjust is used to house and to actuate the clutch housing. This part is available as an individual replacement part, please refer to illustrated part list for related parts.