27726 (Type 1) Black and Decker Angle Grinder - Parts

This is a genuine OEM replacement backing flange used on grinders. This part helps to hold the grinding disk to the unit. It is made out of metal and it is sold individually. To replace it you would need a spanner wrench.

This is an authentic manufacturer-sourced part which is made for use with Black and Decker and DeWALT angle grinders. The purpose of this clamp is to secure the guard. If the part is damaged or is missing, this will provide an identical replacement for the original component that was installed on a new unit. Refer to the owner's manual fo...Read morer the correct application of this part. Replacing it is a simple task that should only require a screwdriver. One durable metal clamp is included. Note, the screws to secure it are sold separately.

This is an Original Manufacturer Sourced replacement part used on Angle Grinders. This part is made out of Metal and it is Sold Individually. The purpose of this Clamp Nut is to hold the Grinding Wheel to the Spindle Shaft. You would need Box Wrench to secure this part.

This replacement box wrench is a genuine OEM sourced item, it is not an aftermarket imitation. It is a high quality item designed for use with Black and Decker and Dewalt grinders and sanders. This wrench allows you to secure or remove grinding disks. This wrench is made from durable metal and it is sold individually. Please note, spanner wrench is sold separately.

The pinion fits between the ball bearing and the ring. This is an OEM DeWALT and Black & Decker part directly sourced from the manufacturer for use in plate joiners and grinders. This is available as an individual replacement part. It may require a screwdriver and a set of pliers during installation. It is made of metal and will need to be replaced if it breaks.

Genuine Manufacturer Sourced replacement part used on a variety of Power Tools. This part is made out of Metal and it is sold individually. Ball bearings are used to reduce friction between rotating parts. The balls or rollers take the load and spin, distributing the weight evenly while the minimal contact area of the ball reduces frictio...Read moren. This reduces wear on the tool and allows it to run smoothly. Bearings experience constant wear when the tool is in operation from pressure, heat, vibration and friction. Because of this, many Bearings need periodic maintenance or replacement. Included in part number 605511-00

This genuine cord protector, also known as a strain relief boot, is designed to safeguard the power cord where it enters your tool housing. Made from flexible, durable material, it helps prevent the cord from bending, twisting, or fraying during regular use, supporting safe and reliable performance. Small but essential, this component is ...Read morean effective replacement if the original protector is worn or damaged, helping extend the life of your tool and maintain proper cord alignment.

This is an original part sourced directly from DeWalt. This grease was designed for use with the equipment listed below and helps to lubricate the system. This extends the life of the tool and protects parts from usual wear by allowing for easy movement. This item is sold individually.

This is a genuine OEM sourced replacement part that is produced for use with Black and Decker and Dewalt grinders. Two of these screws are used to secure the guard with the clamp. This screw is made from high quality metal and it is sold individually. To remove or install it you will need a Phillips screwdriver.