25331437100 Kenmore Refrigerator - Instructions

simply replaced the pieces directly. It was very easy.
The different parts are easily deciphered and reassembled.

I had to loosen the screw holding the mounting block and increase the hole size to fit the screw on refrigerator

My upper and bottom air diffuser was missing.
Purchased both air diffuser and placed it.

Unplugged fridge. Removed freezer shelves and unscrewed and removed plastic shelf brackets. Removed the lower rear panel. Removed the bin for ice. Removed the 2 exposed upper rear panel screws. At this point I was able to flex the panel quite enough to access the fan motor. Carefully plugged the fridge back in and turned it on long enough to verify the existing evap. fan motor was not running. Powered off and unplugged again. Removed the fan and it's support assembly, and replaced with new. Had to cut the wires and splice and crimp with the provided wire nuts since the plugs in this model were different. Powered on fridge to check fan function. Reassemble and go home looking' like a hero! Saved my BFF a couple hundred bucks.

replaced it

The evaporator coil is behind the freezer. Remove the rack that makes the shelf and remove two 1/4” hex head screws I the back of the freezer to access the coil.
I used a hair dryer to melt the ice off the coil.
The thermostat clips on the refrigeration pipe to the coil. Remove the old thermostat and cut the wires at least a few inches from the thermostat. Clip the new thermostat on the pipe and strip about a 1/4” of the wire ends. The electrical connectors (provided with the new part) must be crimped to connect the wires.

Ordered the right parts thanks to your list of part numbers and where they were located on the refrigerator. They fit perfect and problem fixed in five minutes. This is the best site I have ever used!

Please keep up the good service you provide.

I slid off old caps, then slid on new caps. I pushed down metal holding clamps and I was finished. The whole process was about 5 minutes. The parts select web site was great. I looked up my parts on the easy to use catalog and ordered them. Make sure you save the broken parts or write down the part numbers to make finding your exact parts easier. I wish all parts web sites were as easy to use as parts select.

I had to cut the retainer bar to length and then snap the end caps onto the bar. Then just snap the assembly onto the freezer. No problem!

Just snaps into notches on each side. Bar arrived bent from shipping. Replacement was overnighted at no extra charge. Great service.

I looked at the model number and ordered it through the part select. The delivery was real fast and convenient. Overal we had a very good experience with "Part Select"

take 1/4 hex screws out clean out dust ,remove old fan blade replace with new install bolts .

measured lenght of parts looked at parts available and matched the size and use together slip broken part off door replaced with newpart. reinstall retainer to to door no tools needed.

I snapped out the broken piece of the old Door Shelf Retainer Bar End Cap, snapped in the new one and reinstalled the door rack in my refrigerator.

Your sight and excellent photos made selecting the correct part fast and easy. I received the part with 2 days in perfect condition and my repair was completed in out 2 minutes!

I would definitely order from this site again.