25331430106 Kenmore Refrigerator - Instructions

All Instructions for the 25331430106
76 - 90 of 228

Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!

Search filter:
Clear Filter
Your search term must have 3 or more characters.
Both frig Racks I ordered cracked in the middle from use over 15 yrs
2 of 2 people found this instruction helpful.
  • Ray from EAST ROCKAWAY, NY
  • Really Easy
  • Less than 15 mins
took out all items off the shelves from frig - followed the instructions on Steve's video
installed 2 new racks replaced all items on the shelves everything worked fine
Was this helpful?
Thank you for voting!
Was broken
2 of 2 people found this instruction helpful.
  • Donna from EDGERTON, OH
  • Really Easy
  • 15 - 30 mins
The repair was not the issue. When I received it there was no protection packing, no invoice and if you call the number, no one is there to help. The rack was plastic with no protection in box and it was damaged. Tried to resolve this matter with no response. Will never go through part select again.
Was this helpful?
Thank you for voting!
freezer cold and frosting up but refrigerator warm
2 of 2 people found this instruction helpful.
  • Gary from SABINSVILLE, PA
  • Very Easy
  • 15 - 30 mins
  • Nutdriver
inside the freezer compartment, remove four hex head screws from rear panel,lift panel forward and unplug wire assembly from panel. find old defrost thermostat attached to copper tube by clip on back of thermostat, unclip, snip two wires to thermostat, take new thermostat, strip 1/4"of wire from wires in freezer (thermostat is prestripped ),insert light blue wire from thermostat and light blue wire from freezer into opposite ends of crimp connector and crimp securely. repeat with dark blue wires. set panel back in freezer,connect plug to back of panel, refasten screws and you are go to go! save yourself the price of a new refrigerator or $300 repair by repairman!
Was this helpful?
Thank you for voting!
Freeze would not re-start after temp rose above 23 degrees.
2 of 2 people found this instruction helpful.
  • Andy from GOOSE CREEK, SC
  • Really Easy
  • 15 - 30 mins
  • Screw drivers
Unplugged the freezer. Located the Run Capacitor (next to the compressor). Removed the wire holding bracket, removed the Run Capacitor from the Start Relay. Installed the NEW Capacitor, re-installed the holding bracket. Plugged the unit in, looking at the display for the proper start-up sequence data. All is good - freezer operating for a nother 10+ yrs. NOTE: When removing the Run Capacitor, beware the COMPRESSOR could be HOT to the touch.
Was this helpful?
Thank you for voting!
The Refrigerator was not cooling properly. At 40-45 degrees milk spoiled
2 of 2 people found this instruction helpful.
  • Marcos from E STROUDSBURG, PA
  • Really Easy
  • 15 - 30 mins
  • Socket set
My upper and bottom air diffuser was missing.
Purchased both air diffuser and placed it.
Was this helpful?
Thank you for voting!
No problems
2 of 2 people found this instruction helpful.
  • Karamo from MADISON, WI
  • Really Easy
  • Less than 15 mins
Easy to install. It is self explanatory. You do not even need a manual or video explanation.
Was this helpful?
Thank you for voting!
Light Switch too loose so no longer triggered by the door.
2 of 2 people found this instruction helpful.
  • Linda from BOZEMAN, MT
  • Very Easy
  • Less than 15 mins
Googled it on Youtube - unplugged the fridge, used a paint scraper to loosen the old light switch, unplugged it from the electrical source, connected the new switch, replaced the whole unit into the proper location and pushed it firmly into place.
Was this helpful?
Thank you for voting!
Lost the temperature control know
3 of 5 people found this instruction helpful.
  • John from Pilesgrove, NJ
  • Really Easy
  • Less than 15 mins
The knob came in the plastic package. It was the correct part. I opened the package and placed the knob on the prongs. Now it works fine.

Thanks
John S.
Was this helpful?
Thank you for voting!
Refrigerator too warm
2 of 2 people found this instruction helpful.
  • James from N RICHLND HLS, TX
  • Really Easy
  • 30 - 60 mins
  • Nutdriver, Screw drivers
The parts were easily replaceable. No special instructions needed. Just identify and remove and replace. I didn't know which specific part needed to be replaced (both reported to fix my problem) but neither part was very expensive so I replaced both. No special tools needed. 1/4" nutdriver and phillips head screwdriver. Repair took ab out 30 minutes. I did have to make an adjustment on the defrost timer (a small dial on the unit) I just set it how the old part was set. I immediately knew it was going to work when I plugged the refrigerator back in and the fan motor inside the freezer kicked on. Easy peesy...
Was this helpful?
Thank you for voting!
Refrigerator not working, freezer working
2 of 2 people found this instruction helpful.
  • Stephen from VAN WERT, OH
  • Easy
  • 30 - 60 mins
  • Nutdriver
I initially replaced the defrost timer, and later replaced it and the defrost thermostat. The defrost thermostat was the faulty component
Was this helpful?
Thank you for voting!
Condenser motor burned out
2 of 2 people found this instruction helpful.
  • Bill from STERLING, VA
  • Easy
  • 30 - 60 mins
  • Nutdriver, Socket set
I followed the instructions on your website, made it a simple as possible. Very tight work area sometimes fingers only, but a little patience works.
Saved at least $300. By not paying a repair person.
Was this helpful?
Thank you for voting!
the freezer frosted up and the fridge was not getting cold.
2 of 2 people found this instruction helpful.
  • Sherry from Newberry, SC
  • Easy
  • 30 - 60 mins
  • Nutdriver
I watched the instructional video and did what it said.
Was this helpful?
Thank you for voting!
Fan was off kilter and began rubbing the frame which is caused it to slow down and make an disturbing audible noise.
2 of 2 people found this instruction helpful.
  • Martin from N HOLLYWOOD, CA
  • Really Easy
  • 30 - 60 mins
  • Screw drivers, Socket set
Before buying the part, I watched your video and realized it was extremely simple to remove and replace. Item was to take 7-10 days and I received it in 4. Took longer than 15 minutes because I had to move the fridge forward, get my tools and a vacuum, get a cup of coffee and get to it. Very easy and the video was exactly step by step. It took longer to vacuum all of the dust bunnies than to replace the part.

Honestly, I was in the market to buy a new refrigerator but now I believe I'll wait several more years. Thank you for your support.
Was this helpful?
Thank you for voting!
Refigerator not cooling
2 of 2 people found this instruction helpful.
  • Carlos from MOSINEE, WI
  • Really Easy
  • 30 - 60 mins
  • Screw drivers
I followed your video instructions, is very important to have this information.
Was this helpful?
Thank you for voting!
Frost in freezer, fridge not cold
2 of 3 people found this instruction helpful.
  • Bob from Pinole, CA
  • A Bit Difficult
  • 30 - 60 mins
From most posts I've read, the defrost timer was the culprit so I blindly ordered one. Easy install but did not fix the problem so I broke out the ohm meter. The only other 2 items it could be all tested good with my meter so I bypassed the defrost thermostat (per forum help...actually quite easy)and it defrosted fine, which told me I nee ded a new defrost thermostat. Installed fairly easy and problem gone.
Was this helpful?
Thank you for voting!
All Instructions for the 25331430106
76 - 90 of 228