25331424104 Kenmore Refrigerator - Parts

This defrost timer will cycle for thirty minutes after every eight hours of run time.

This 40-watt appliance light bulb is a reliable replacement for use in select ranges, refrigerators, freezers, and microwaves. It provides bright, consistent lighting to help you see clearly inside your appliance. Installation is simple—just unscrew the old bulb and replace it with the new one. If the existing bulb is broken, disconnect p...Read moreower and use needle-nose pliers to safely remove the remaining base. Sold individually, this bulb is a commonly replaced part—consider keeping a spare on hand.

This defrost thermostat is a critical component in the refrigerator’s defrost system, designed to prevent overheating during the defrost cycle by regulating the temperature around the evaporator coils. Positioned within the freezer compartment, it monitors coil temperature and interrupts power to the defrost heater when safe limits are re...Read moreached. A malfunctioning thermostat may result in uneven cooling, excessive frost buildup, or a warm refrigerator compartment despite a cold freezer. Replacing this part restores proper defrost function and helps maintain consistent internal temperatures and energy efficiency.

This kit includes the motor, clips and terminal connectors. This part has been updated by the manufacture. This evaporator fan motor is located in the back of the freezer, and circulates air over the refrigerator coils. These coils will convert the heat into cool air, which is then circulated.

This part blows air over the condenser.

Improve door function and alignment with this hinge nylon washer, designed to support the door as it pivots on the hinge pin. Made from durable nylon, it helps reduce friction and noise while ensuring smooth opening and closing. By maintaining proper door positioning, it supports a secure seal and contributes to efficient operation and consistent cooling performance.

This thermostat helps your fridge stay at the right temperature by turning the compressor on and off as needed. If your fridge is too warm or too cold, this part might be the fix. It’s made to fit certain models and helps keep your food fresh by keeping the cooling consistent. Easy to install—just unplug your fridge first and follow your manual for guidance.

This is a replacement condenser fan motor kit for your refrigerator. This six-piece kit contains foam tape, 2 screws, the fan blade, the new motor mounting bracket, and the condenser fan motor. The condenser fan motor is found in the back of the refrigerator, and it moves air across the compressor and the condenser to keep them cool. If t...Read morehe motor has failed, the condenser and the compressor will run hot, and this can cause the refrigerator not to cool. This is an OEM part from the manufacturer.

Sold individually. NOTE: For 18 cubic feet refrigerator model order part # 240358005 for the shelf and part# 3201150 end caps, quantity 4.

This is the replacement light switch for your refrigerator. It is white in color and is approximately 2inches long and 1 inch wide. If the light is not working or stays on, you may need to replace the switch. It is an OEM part, directly from the manufacturer. Be sure to disconnect the refrigerator from the power source before you begin th...Read moreis repair. To remove the switch, simply use a flathead screwdriver to pop the switch out from the refrigerator wall, then disconnect the wires. Reconnect the wires to the new switch and snap it into place to complete your repair.

Sold individually.