245432-0519-E1 Briggs and Stratton Engine - Parts

This is a genuine OEM supplied replacement carburetor float designed for lawn and garden equipment engines. This float controls fuel flow into the carburetor bowl by adjusting the needle valve. Includes a plastic float and a metal pin used to secure the float. To complete this repair you would need a wrench and pliers. • Make sure to ...Read moreremove the spark plug • Remove carburetor bowl • Remove old float and secure the new one in place • Re-assemble and test the unit

It is a genuine item that is supplied by the original equipment manufacturer for Briggs and Stratton engines commonly installed on a variety of lawn and garden equipment. This is a special component that provides a tight seal for the PTO side of the crankcase. Over time it may wear out and begin to crack eventually requiring a replacement...Read more. Check the appropriate diagrams for your specific model to ensure the correct installation of the new seal-oil. To perform this repair you will need a variety of tools such as a screwdriver, a wrench set, pliers and a tool to pick out the old seal. Make sure to drain the oil before starting this repair. Keep in mind, one durable rubber part is included.

This is a Genuine OEM replacement part used on variety of Lawn and Garden Equipment Engines. This part is made out of Rubber and it is sold individually. If the carburetor is leaking fuel it is recommended to replace the Bowl Gasket. Gaskets and O-rings are a common source of problems. They eventually shrink, causing fuel and air leaks that lead to poor engine performance.

This is a genuine manufacturer approved carburetor needle valve for lawn and garden equipment engines. The needle valve opens and closes to control the flow of fuel into the carburetor. It is made out of metal and it is sold individually. You would need a screwdriver and pliers to complete this repair.

The control knob is part of the speed control panel. This item is made of plastic and is sold individually. It is an authentic OEM sourced item which is specifically produced for use with blowers, engines, generators, and vacuums made by Briggs & Stratton and Toro. It may require a set of pliers during installation. This part may become broken and will need to be replaced.

This is a geniune OEM part. The Briggs & Stratton, 10-16 amp voltage regulator is composed of metal, wiring and plastic parts. The regulator is compatible with many lawn and garden machines. This part is connected to the engine's terminals, and has been designed to manage the voltage in the device's electrical system. A screwdriver and a ...Read moresocket set are needed in making the removal and repair. It is recommended to refer to the manual and diagrams for repair instructions. This item is sold individually.

This part is an OEM from Briggs & Stratton. The switch and key is compatible with many small engines. This ignition component is sold individually, and includes a washer, nut, decal and key set. Please refer to specific manual and diagrams for making the repair. A screwdriver, pair of pliers and a wrench set are often necessary for the installation.