19985 (1988) Kenmore Dishwasher - Parts

This complete pump seal kit comes with four black rubber rings, a white fiber gasket, and a screw.

Metallic screw that is less than an inch long. Does not include the plastic washer.

This kit includes spring, retainer and protective tip. It is recommended to replace both springs at the same time.

The lower rack provides easy loading with flexibility for small and large items, and helps hold the dishes in place during the wash and dry cycle. The rack measures approximately 22-inch x 21-inch. The rack is light gray in color with wheels included, lower fold down, and a flexrow retainer. This is a genuine OEM part.

This clamp helps to prevent leaking by holding the end of water hose in place.

A rusty or bent upper rack can make dishes hard to load and may block the spray. The replacement rack provides storage for smaller dishes and slides along the upper rails. First check the wheels, clips, adjusters, spray parts, and rail stops for wear. These items are not included with the rack. Match the rack to the complete appliance mod...Read moreel and compare its size and mounting points. Remove all dishes, support the rack while sliding it out, and note where each part fits. After installation, make sure the rack moves freely and cannot leave the rails.

This new style nozzle cap has a rubber pressure seal attached. The rubber seal holds the lower spray arm down and in place.

Sold individually. The size of this screw is 1/4" hex head and 10-12 x 1/2".