1. Home
  2. 1552
  3. Instructions

1552 Range - Instructions

All Instructions for the 1552
76 - 81 of 81

Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!

Search filter:
Clear Filter
Your search term must have 3 or more characters.
broke end cap while moving range
  • Alan from Muskego, WI
  • Really Easy
  • 15 - 30 mins
  • Screw drivers
unscrewed broken end cap, removed from handle and replaced the new end cap
Was this helpful?
Thank you for voting!
The burner bowls were encrusted with grease and spills.
  • Ed from Canyon City, CO
  • Really Easy
  • 15 - 30 mins
I easily took out the old ones and put in the new ones sent by Part Select. As promised they fit perfectly. Now when my wife cooks there is no more smoke and it does not set off the smoke detector.
Was this helpful?
Thank you for voting!
The door handle end caps did not fit on to the handle far enough. this caused the screw hole spread to be too wide, Also the new end caps had two nipples outside the bolt holes that the original brackets did not have.
  • Michael from South Bend, WA
  • Difficult
  • More than 2 hours
  • Screw drivers
The reason the brackets didn't go on to the handle far enough was there was a molding defect inside one of the brackets. After alot of scraping at the inside of the bracket and lightly tapping with a soft hammer I was able to get the defective bracket on so that the holes lined up to the mounting plate. As for the extra nipples I had two options. Either cut the nipples off or drill some holes in the metal plate that the brackets attach to. I chose the latter. I had to attach the brackets to the plate with extra long screws, reach in under the bracket with a scribe and mark the nipple location on the plate. Then I removed the handle and drilled two holes for each bracket. After some minor adjustments to the holes I was able to attach both brackets and reassemble the oven door.
Read less
Was this helpful?
Thank you for voting!
plastic sockets in end caps for connection screws broke off
  • cornelius from Hollister, CA
  • A Bit Difficult
  • More than 2 hours
  • Pliers, Screw drivers, Socket set
Very detailed repair instructions on internet made installation of new end caps a job not needing a professioal.
Was this helpful?
Thank you for voting!
Broken oven door handle. Needed the brackets and screws to repair it.
  • Margaret from Cogan Station, PA
  • Really Easy
  • More than 2 hours
  • Screw drivers
removed the broken parts and screwed on the new parts.
Was this helpful?
Thank you for voting!
broken door handle
  • Joan from Schererville, IN
  • Really Easy
  • 1- 2 hours
  • Nutdriver, Screw drivers
repair was easy and the video was very good. My only problem, I had to go buy a tool, I did not have a nut driver.
Was this helpful?
Thank you for voting!
All Instructions for the 1552
76 - 81 of 81