15021 Briggs and Stratton Engine - Parts

This is a genuine OEM approved replacement part which is specially designed for use with Briggs and Stratton engines commonly installed on Toro lawn and garden equipment. The fuel line is what delivers the fuel from the tank into the carburetor. Over time the material may deteriorate and begin to crack eventually requiring a replacement. ...Read moreKeep in mind this high-quality rubber line is sold individually, note that it includes two metal clamps to secure the hose. Make sure to refer to the appropriate diagrams of your model for the correct location and application of this part.

This is an authentic replacement part that has been OEM sourced to be used with snowthrower and lawnmower engines from Briggs & Stratton and Toro. The gasket is used to seal and provide spacing on both sides of the carburetor insulator. It is recommended to replace gaskets when servicing the engine to ensure proper seals when the parts are reassembled. This gasket is sold individually.

This is an original Briggs & Stratton replacement part. The piston lock pin is commonly found in small engines. This part is made of metal, and is used to hold the piston pin in place in the piston. You may require needle-nose pliers when replacing this part. This item is sold individually.

This authentic item is supplied directly from the original equipment manufacturer for use with engines, outboard motors, portable generators, snowthrowers, and lawn mowers made by Briggs & Stratton and Toro. The o-ring seal attaches to the dipstick. When replacing this part a socket set might be required during the installation process. I...Read moret is made out of rubber and will need to be replaced if it breaks. This part is available as an individual replacement.

This screw is a an original Briggs and Stratton part used in small engines. The durable brass screw is flanged with a hexagonal head. The screw is used to secure the oil sensor, and is sold individually.

Used With 3MM Diameter Starter Rope

This is an original replacement part sourced directly from the manufacturer. The control lever is commonly found in engines, generators, and pressure washers from Briggs & Stratton, and in lawn tractors from Toro. This part is made of metal, and is used to adjust the control wire that connects to the engine. You may require a wrench or...Read more screwdriver when replacing this product. This item is sold as an individual replacement part.

This timing key is an OEM direct from Briggs & Stratton. The metal component is compatible with many small engines, and is sold individually. The key secures the shaft in the crankshaft. A wrench is often required for making the replacement.