13623 Briggs and Stratton Engine - Parts

This is an authentic Briggs & Stratton replacement part, sourced from the original manufacturer for use with lawnmower engines. The special screw is commonly used to secure the engine's crankcase cover. This screw is sold individually, please note eight screws may be required.

This 1/4-inch?20 UNC hex-head screw is 1 inch long. It secures a part on select small gasoline engines, but its exact location can change by model. Use the full engine model, type, and code numbers to guarantee the proper fit and placement. Turn off the engine, let it cool, and disconnect the spark plug before service. Check the mounting ...Read morehole and nearby parts for damage. Tighten the screw to the setting listed in the engine manual.

This is a genuine OEM sourced part which is specially designed for use with Briggs and Stratton engines commonly installed on lawn and garden equipment. It is an identical replacement for a missing or faulty screw that was installed on a new unit. Please make sure to refer to the appropriate diagrams of your model for the correct location...Read more and application of this hardware. Keep in mind this high-quality item is made of durable metal and is sold individually.

This replacement screw is a genuine hardware that is supplied directly from the original equipment manufacturer for use with Briggs and Stratton engines commonly installed on lawn and garden equipment. This part is made of high-quality metal and it is sold individually, you will need either a wrench or a flat-head screwdriver to install or remove it.

Clutch-Drive

The stop switch is made of plastic and metal and helps to turn off the device. This is an authentic replacement part that is sourced from the original manufacturer for use with engines, generators, snowthrowers, and blower-vacuums made by Toro, Murray, and Briggs & Stratton. This part is available individually. During the installation pro...Read morecess, a wrench set and wire stripping pliers might be needed to replace this part. It may become bent or broken and will need to be replaced.

This is a genuine Briggs & Stratton and Toro replacement part for use in blowers, engines, generators, lawn mowers, lawn tractors, pressure washers, snowblowers, and vacuums. The insulator is made of plastic and metal. A set of pliers may be needed during the replacement of this part. It will need to be replaced if it breaks. This item is sold individually.

This is an OEM replacement part, sold individually. This Grommet is an elbow for the crankcase breather tube. These rubber elbows were just a convenient way to make a 90 degree bend back when they used metal tubing. Compatible with the equipment shown below.