13527 Craftsman - Parts

This is an authentic OEM part made by original manufacturer. It is compatible with various Skil and Bosch saws. Ball bearings serve as a buffer between metal parts. They also stabilize for proper positioning/direction of moving parts. Ball bearings need frequent replacement because of their high-wear function. This steel ball bearing is sold individually. Seals, o-rings, etc. are sold separately.

This is an authentic Craftsman replacement part, sourced from the original manufacturer for use with worm drive circular saws. The metal lever assembly is used to adjust and lock the position of the bevel angle and depth of the saw's blade. This kit includes the lever, retaining clip, and the acorn nut. The lever assembly kits are sold individually and complete with all the parts pictured.

This item has been sourced from the original manufacturer and is intended to be used with circular saws from Skil and Bosch. The retaining ring is used to secure the lower blade and to provide spacing for the spindle. This item is available as an individual replacement part.

This is a genuine OEM part sourced from the manufacturer and it is used on Circular Saws. This part helps to secure the Blade. It is made out of Metal and it is Sold Individually. Washer provides a bearing surface for fastener load distribution and acts as a spacer. To replace this item you would need a Wrench.

This genuine OEM replacement part is manufactured for worm driven circular saws. This worm gear set includes both gears, and the bearing for the gear on the arbor shaft. It is recommended to replace the gaskets to ensure a seal when reassembling the tool. The set is sold individually, please see model diagram for additional parts.

Genuine manufacturer supplied replacement brush set designed for use with Craftsman worm drive saws. Due to constant contact with an armature brushes will gradually wear down and will require replacement. It is advised to replace both brushes at the same type. This assembly includes two (2) carbon brushes with lead wires and springs atta...Read moreched. Please note brush caps are sold separately. You would need a screwdriver to complete this job. • Make sure the unit is unplugged • Remove the brush cap and take out the old brush • Secure the new brush with a cap and test the saw

• This cord guard is a genuine Skil replacement part and is sold individually. • Cord guards, also called cord protectors, are designed to slide onto your cord and fit securely at the end, where it's firm rubber will protect the base of the cord from getting bent and pinched, which can expose the wires and become a safety hazard. • T...Read morehis cord guard will fit cords for the tools listed under the "Compatible Tools" listing. It is not guaranteed to fit any other cords.