13-2 - Overview

This surface burner terminal block kit comes with interchangeable mounting brackets, terminal box, ceramic wire nuts, heat shrink protective tubing and wires.

This drip bowl is located beneath the element and catches any spills. It is sold individually and has a diameter of approximately 10 inches.

This drip bowl is sold individually. This part is located beneath the element and catches spills from cooking.

The coil burner element is eight inches in diameter. It has four turns, 220 volts and looped terminal ends. The coil burner element provides heat to the cooking surface on your range. You might need to replace this part if your element is not heating. It might have shorted out around the coil or the terminal block; you can test the coil t...Read moreo see if the burner or the switch may be at fault. Please make sure the power has been disconnected and the element is turned off and had time to cool before starting your repair. The element is a genuine OEM part and is sold individually.

Sold individually. This part is sold individually. This is a part for your stove top. The surface element is what your cookware sits on. The element supplies heat at varying temperatures. This may need to be replaced if the coil has shorted out or the terminal block shorted, and this caused the connectors at the end to burn out. The eleme...Read morent is set in place by springs. You will need to push the springs in to release the old element. Make sure the drip bowl is lined up with the terminal block and press the new element into place.

This switch controls the stove top surface burner.

This is an authentic mounting screw, which works with ranges, wall ovens, cooktops and warming drawers.

Bring steady heat back to a large cooking area with this 8-inch electric coil element. Rated at 2,100 watts, it turns electrical power into heat for boiling, frying, and other stovetop tasks. The burner has five coil turns, looped terminals, and a chrome center cap. Replacement may be needed when the old element does not heat, works only ...Read moreat times, or has visible cracks, blisters, or burned areas. Check the burner socket for damage before installation. Unplug the range or switch off its circuit breaker, let the cooking surface cool, and wear work gloves before removing the old element.