12H802-310 Briggs and Stratton Engine - Parts

This is an authentic replacement part manufactured for use with small engines. The special wrench is used to fasten and remove the spark plug while maintaining the engine. This spark plug wrench is available as an individual replacement part, please see model diagram for associative parts.

This genuine replacement magneto is designed for Briggs & Stratton engines used in Toro lawn mowers. It plays a vital role in the ignition system by generating the electrical current needed to fire the spark plug. Made from high-quality materials, this part is sold individually. Note: The spark plug boot is sold separately. To replace...Read more the magneto, begin by removing the housing or covers from your mower. Next, remove the spark plug and bind the cylinder to prevent it from turning. Disconnect the ignition wires and remove the old ignition coil. Install the new magneto, carefully setting the correct air gap between the coil and the flywheel. Once installed, reassemble the unit and test for proper operation. A screwdriver set is recommended for this repair.

This is an original replacement part sourced directly from the manufacturer. The control lever is commonly found in engines, generators, and pressure washers from Briggs & Stratton, and in lawn tractors from Toro. This part is made of metal, and is used to adjust the control wire that connects to the engine. You may require a wrench or...Read more screwdriver when replacing this product. This item is sold as an individual replacement part.

This timing key is an OEM direct from Briggs & Stratton. The metal component is compatible with many small engines, and is sold individually. The key secures the shaft in the crankshaft. A wrench is often required for making the replacement.

This authentic item is supplied directly from the original equipment manufacturer for use with engines, outboard motors, portable generators, snowthrowers, and lawn mowers made by Briggs & Stratton and Toro. The o-ring seal attaches to the dipstick. When replacing this part a socket set might be required during the installation process. I...Read moret is made out of rubber and will need to be replaced if it breaks. This part is available as an individual replacement.

This is available as a set of four rings. They are authentic OEM sourced items which are specifically produced for use with Briggs & Stratton engines. The rings are part of the piston assembly and are made out of durable materials. If these parts become broken they will need to be replaced and may require a set of pliers during the installation.