12891-2 General Electric Range - Instructions

Easy

Followed the instructions

By myself

turn off the power at the breaker first

remove the 2 screws under the 'lip' of the stove top (open the oven door to get to them)

prop up the stove top on the cardboard box the part came in

pull off the wires one by one and attach to the new burner OR record where each wire goes first

remove the old burner (2 screws) and attach the new burner

screw down the stove top

try the burner - when it does not work flip the power breaker back on and then try again

bask in the joy, admiration and wonder directed your way by various family members

popped the new one on!

I ordered a new burner assuming As is turns out: nothing wrong with the burner.

Couple of screws and it was done. Simple and inexpensive since I thought I was going to have to buy a new range.

Turned the wire protector to the side. Turned out the old bulb and replaced it with the new. Turned the wire protector back in place and I'm like new.

Dear PartSelect:

I am very impressed by your service and company. My order arrived in less than 24 hours. It was a perfect match and is currently in service. I am very satisfied with the entire experience and will use your company again.

I simply opened up the cooktop with a screwdriver and disconnected the wires to the affected burner. After the part arrived, I reconnected them. I had to swap over two brackets from the old burner, so don't throw it away until the new one arrives. It went back together very easily and worked immediately.

Matt Brennan

Removed the screws around the inner part of the door. Removed the knob from the door latch, then pulled back the inner door panel. The hardest part was tracing the lost voltage wthout a wiring diagram. I got a tip from a friend so I checked the rocker switch (heated dry switch) and it was intermittently open, also one of the 1/4" plugs that plug onto it had been hot. I replaced the switch and the connector and now it works fine.

remove the door, removed about six screws and did a clean up on the glass. the replacement part was screwed back in place. so easy

Locate breaker box and turn off breaker to stove. Removed the two screw in front that hold the top in place. Raised the top and supported it with the box the new burner came in. Removed two screws that held the burner in place and the 5 wires one at a time an installed them on the new burner. Put new burner in place and installed two mounting screws. Reinstalled the two screws in the front to hold the top in place then turned the breaker back on and tested burner. Worked great. Received part in 2 days.

Removed the old handle with the new one.

Unscrewed bottom screws, replaced trim. No trouble.

Followed directions that I found on the internet and it was easy to remove the old burner and replace it with the one I ordered from you. There was no problems at all.