128607 Briggs and Stratton Engine - Parts

This spark plug terminal is supplied directly from the original equipment manufacturer. The metal terminal is designed to fasten the spark plug to the engine lead wire. This component is sold individually, and needle nose pliers are helpful with the repair. Please refer to the appropriate diagrams of your engine model for the proper application of this hardware.

It is a genuine manufacturer-approved part which is specially designed for use with Briggs and Stratton engines commonly installed on lawn and garden equipment. The purpose of the switch-interlock is to act as a safety feature which will shut the engine off. Unfortunately, over time parts will wear out and it may begin to fail eventually ...Read morerequiring a replacement. Refer to the owners manual and the appropriate diagrams of your model for the correct location and installation of this component. Note, this high-quality plastic body switch-interlock is sold individually.

This manufacturer approved recoil starter pulley is designed for lawn and garden equipment engines. The recoil starter engages the drive cup on the flywheel to start the engine when pulled. This assembly includes: Plastic Pulley and a Metal Recoil Spring.

The choke shaft attaches to the choke seal. This part is sold individually and is made out of plastic. It is a genuine Briggs & Stratton part sourced directly from the manufacturer for use in motors and engines. A socket set and a wrench set might be required during the replacement of this part. It will need to be replaced if it becomes broken.

This is an authentic OEM component from Briggs & Stratton. The magneto armature screw is compatible with many lawn and garden engines. The hardened metal screw helps to mount the magneto armature. A wrench is required for the removal and installation. The magneto armature screw is sold individually. It is recommended to refer to engine manual and diagrams for further instruction.

This is an original part from Briggs and Stratton and Toro for use with Lawn Mowers. The gasket intake is fitted between the intake insulator and the cylinder cover. The most common reason for replacing a gasket is if it is damaged or missing, which can allow foreign materials to enter the engine's intake, causing it to run poorly or not ...Read moreat all. This part is sold individually. The tool that you will need to replace the gasket-intake is a 10mm socket.

This is an authentic replacement part manufactured for use with Briggs and Stratton small engines. The special intake gasket seals the connection between the breather tube and carburetor. It is recommended to replace the gasket when servicing the carburetor, or air cleaner to assure a good seal when reinstalling the parts. The intake gasket is sold individually.

Kit-Carb Overhaul

This fuel tank is for lawn and garden equipment engines. Fuel tank holds the gas that's needed by the engine. Work in a well-ventilated area when installing this part. Drain the existing fuel from the tank and disconnect the spark plug wire before beginning the repair.

This item has been OEM sourced to ensure quality. The spark plug is intended to be used with outboard motors and lawnmower engines from Briggs & Stratton. The spark plug threads into the cylinder and is used to create an electric arc that ignites the air/fuel mixture inside the combustion chamber. A spark plug wrench may be needed to install this part. This item is sold individually.

This is a genuine manufacturer-sourced replacement gasket which is specially designed for use with Briggs and Stratton and Toro lawn and garden equipment. It provides an air-tight seal for the carburetor, please refer to the appropriate diagrams of your model for the correct location and application of this hardware. Over time the materia...Read morel may wear out and begin to crack eventually requiring a replacement, keep in mind this high-quality composite material component is sold individually.