1250 - Parts

This modular ice maker assembly replaces worn-out units to restore ice production in refrigerators. It includes the ice mold and control device but excludes the cover, ice level arm, wire harness, and mounting hardware, which must be reused or ordered separately. Unplug the refrigerator before installation and use work gloves for safety. Check compatibility with your model number before purchase.

This is a multi-use and multi-appliance screw. It can be used on a microwave, refrigerator, range/oven, air conditioner, dehumidifier, washer, or dryer. The measurements of this screw are 8 x 1/2 inch. It has 6 threads. Refer to the manual provided by the manufacturer for further information on repair and accurate guidance. Remember to wear work gloves as a safety precaution.

Sold individually.

This icemaker water inlet cup is three inches long. It is all white in color and is made of plastic.

This part is also known as the cycling thermostat and this bi-metal device controls the activation of the icemaker ejection cycle.

The water inlet valve is a solenoid-operated switch located at the bottom of the refrigerator. When it is energized by electrical power, water is released from the supply line through the water valve and into the compact icemaker mold. ***Please NOTE: This part has been redesigned and may appear different than the original. It has a new...Read more quick connection. To install: cut the retaining nut off the existing water line and gently push into new valve. To remove: depress the ring that the tube slides into.

Holds the ice when it's released by the ice maker.

This compression nut is used with the plastic water line of the icemaker assembly.

1/4" Plastic tubing, 8 1/2 feet long.

This part strips ice from the icemaker mold during the ejection cycle to prevent ice pieces from falling back into the mold.

This screw is sold individually.