124T02-2 Briggs and Stratton Engine - Parts

It is a genuine component that is supplied directly from the original equipment manufacturer for use with Briggs and Stratton engines commonly installed on lawn and garden equipment. This is one of the special screws utilized to secure the muffler, please refer to the appropriate diagrams of your model for the correct location and use of ...Read morethis hardware. It is a high-quality component which is made of durable metal and is sold individually.

This is an OEM part sourced directly from the manufacturer. The crankshaft is commonly found in Briggs & Stratton engines. This part is made of metal, and is driven by the pistons to create rotational motion within the engine. This item is sold individually.

This is an authentic OEM replacement part used on lawn and garden engines. The purpose of this part is to mix air and gas before the fuel mix goes to the engine. This Carburetor is a auto-choke system. If the engine won't start and the tank is full of fresh fuel, test the carburetor by removing the air filter and pouring about a teaspo...Read moreon of fuel into the carburetor. Pull the starter rope. If the engine starts and then quickly dies, the carburetor is likely the problem. This assembly includes a metal body carburetor, rubber o-ring and a gasket. When replacing carburetor it is advised that you also replace carburetor gaskets to ensure proper air tight seal for optimum performance. You will need a screwdriver to perform this repair.

This genuine OEM sourced part is specially designed for use with Briggs and Stratton engines that are commonly installed on lawn and garden equipment. The pin-float hinge is utilized to secure the float. It is an identical replacement for a missing or a damaged hardware that was installed on a new unit. Refer to the diagrams for your mode...Read morel to ensure the correct repair procedure. Keep in mind this high-quality pin-float hinge is sold as an individual item. You will need pliers to replace this component.

This crankshaft is designed to convert piston movement into smooth rotational power for small lawn and garden engines. Built from high-strength materials for durability and proper balance, it helps maintain consistent engine performance and reliable operation. Ideal for major engine repairs, it restores dependable power delivery when replacing a worn or damaged crankshaft.

It is a genuine OEM supplied replacement part that is specially designed for Briggs and Stratton engines that are commonly installed on Toro lawn and garden equipment. This is the timing gear for the crankshaft, its purpose is to help synchronize the rotation of the crankshaft and the camshafts so that the engine's valves open and close a...Read moret the proper times during each cylinder's intake and exhaust strokes. Please note this durable metal timing gear is sold individually.

This is an authentic OEM part for use with Briggs and Stratton Lawn and Garden Equipment Engines. The intake manifold carries the fuel and air mixture from the carburetor to the engine cylinder. This part includes the gasket, screws, The tool that you will need to replace the intake manifold are a screwdriver, pliers and a wrench set.

This is an original Briggs & Stratton replacement part. The ring set is designed by the manufacturer for use in engines and lawn tractors. This is a set of five metal piston rings, which are inserted into grooves in the outer surface of the piston to seal it within the cylinder. You may require a wrench and pliers when replacing this item. This part is sold individually.