12303 (1988) Kenmore Range - Parts

This surface burner knob is a little under two inches in diameter. It is a black knob with gray numbering indicating the temperature level of the surface burner: low, medium, high, off, and lite. Made entirely of platic, this knob will accept a 'D' shaped shaft.

This is a multi-use and multi-appliance screw. It can be used on a microwave, refrigerator, range/oven, air conditioner, dehumidifier, washer, or dryer. The measurements of this screw are 8 x 1/2 inch. It has 6 threads. Refer to the manual provided by the manufacturer for further information on repair and accurate guidance. Remember to wear work gloves as a safety precaution.

This hinge is located on each side of the oven door. The hinges control the rate that the oven door opens and closes, and allows the door to stay open at an angle. This hinge can be used on either the left or right hand side of your oven, and is approximately 20 1/2 inches long. If your oven door will not open or close easily, you may nee...Read mored to replace this part. It may be a good idea to replace both hinges at the same time. If a spring has become loose on one hinge, the other hinge is likely to have the same issue. The repair is simple and only requires a Phillips screwdriver and a small bent nail. For a full step-by-step guide, check out the video below.

This screw is sold individually.

This spark igniter electrode has a 35" wire lead.

This front burner assembly is almost nine inches long. It is made of metal.

This bracket supports the front and rear burner assembly.

This spark ignition valve switch is an inch and a half long. It is a white switch with a black cam. Sold individually.

This screw is sold individually.

Sold individually.

When the gas burner valve knob is depressed and turned, this part creates a spark that lights the gas and starts the burner.