120607 Briggs and Stratton Engine - Parts

It is a genuine manufacturer-approved part which is specially designed for use with Briggs and Stratton engines commonly installed on lawn and garden equipment. The purpose of the switch-interlock is to act as a safety feature which will shut the engine off. Unfortunately, over time parts will wear out and it may begin to fail eventually ...Read morerequiring a replacement. Refer to the owners manual and the appropriate diagrams of your model for the correct location and installation of this component. Note, this high-quality plastic body switch-interlock is sold individually.

This spark plug terminal is supplied directly from the original equipment manufacturer. The metal terminal is designed to fasten the spark plug to the engine lead wire. This component is sold individually, and needle nose pliers are helpful with the repair. Please refer to the appropriate diagrams of your engine model for the proper application of this hardware.

This manufacturer approved recoil starter pulley is designed for lawn and garden equipment engines. The recoil starter engages the drive cup on the flywheel to start the engine when pulled. This assembly includes: Plastic Pulley and a Metal Recoil Spring.

Kit-Carb Overhaul

This is an authentic replacement part manufactured for use with Briggs and Stratton small engines. The special intake gasket seals the connection between the breather tube and carburetor. It is recommended to replace the gasket when servicing the carburetor, or air cleaner to assure a good seal when reinstalling the parts. The intake gasket is sold individually.

This is an original part from Briggs and Stratton and Toro for use with Lawn Mowers. The gasket intake is fitted between the intake insulator and the cylinder cover. The most common reason for replacing a gasket is if it is damaged or missing, which can allow foreign materials to enter the engine's intake, causing it to run poorly or not ...Read moreat all. This part is sold individually. The tool that you will need to replace the gasket-intake is a 10mm socket.

This is an authentic replacement part manufactured for use with Briggs & Stratton small engines. The special retainer is commonly used as spacing between the head of the valve and the valve spring. The retainer is available as an individual replacement part, please see model diagram for associative parts.

This fuel tank is for lawn and garden equipment engines. Fuel tank holds the gas that's needed by the engine. Work in a well-ventilated area when installing this part. Drain the existing fuel from the tank and disconnect the spark plug wire before beginning the repair.

Used With Plastic Throttle Shaft