113244513 Craftsman Band Saw - Parts

This timing belt is an authentic OEM part from Craftsman for band saws. This part attaches the motor pulley to the wheel to turn the blade. It is recommended to review your models diagram to verify the parts compatibility. This part is made of rubber and sold individually.

Genuine Manufacturer Approved replacement Wheel Tire for some Craftsman Bandsaws. This part is made out of Rubber and is Sold Individually. When putting the tire on a band saw Wheel, it may seem too small but it is not. Band saw Tires will typically come approximately 2 or more inches smaller than the Tire you're replacing. The old Tire s...Read moretretches over time thus becoming less effective and eventually will break. Also, as Tire ages the rubber hardens and allows the Blade to slip. You would need to put the New Tire in Hot/Warm Water to heat the tire enough to make it pliable enough to stretch. Its preferred to use two people in the stretching process.

During the installation process, a wrench will be needed to replace this part. It may become broken or stripped and will need to be replaced. It is an authentic OEM sourced item which is specially produced for use with Craftsman compressors and paint sprayers. The nut is made out of metal. This is available as a pack of eight nuts.

This is an authentic replacement part sourced directly from the manufacturer. The lock washer is commonly found in Craftsman equipment such as compressors, paint sprayers, drill presses, and lathes. This is a set of eight metal lock washers, which may be found in various locations in the machine, depending on model. Please be aware tha...Read moret there are different washers used in the machine. Refer to the parts diagram to be sure of ordering the correct part. You may require a screwdriver or wrench when replacing this item.