110C7 Kenmore Dryer - Parts

This shaft is for the front with right hand thread. Sold individually.

This seal comes with the adhesive backing.

This dryer start switch is a key component that completes the electrical circuit to initiate the drying cycle. Once a timer setting is selected, pressing and releasing the switch activates the dryer. Installation requires a 1/4-inch nut driver and a flathead screwdriver. To replace, first unplug the appliance, remove the rear panel and th...Read moree old switch, then install the new switch and reattach the panel. For detailed guidance, refer to the manufacturer’s installation manual.

This lint filter screen has a white handle. This filter collects lint as it passes through the dryer vent.

This front panel seal kit doesn't include the plastic retainers, reuse the old retainers. No glue is needed, the seal stretches to fit.

Replace the shaft of your left side drum support roller with this part from Whirlpool/Kenmore. This replacement shaft is 2-7/8 inches long. It is meant for use with many of Whirlpool/Kenmore's gas and electric clothes dryers that have been manufactured since 1965. Also known as Drum Roller Shaft.

The thermal cut off fuse will disrupt the power flow to the drive motor when the dryer gets too hot. If your dryer will not heat properly, or will not heat at all the issue could be with a faulty or damaged thermal cut off fuse. Before you replace the faulty cut off fuse, make sure you disconnect the power from your dryer.

This gas dryer conversion kit allows a dryer that is set up for natural gas to be converted for use with liquid propane (LP) gas. The kit includes the key components needed for the conversion, including burner orifices, a regulator vent cap, and a conversion decal. You may need this kit when installing a dryer in a location that uses LP g...Read moreas instead of natural gas. Using the correct conversion kit helps ensure proper gas flow, reliable heating performance, and safe dryer operation after the conversion is completed.

This screw is sold individually.

The blower shaft is 1-5/8 inches long, while the drive shaft is 1-1/4 inches long.

This kit is used for the bottom and side exhaust. The kit includes both the straight and elbow vent.

The WPW10186032 Dryer Timer helps control the drying cycle and is compatible with several Whirlpool, KitchenAid, Maytag, Jenn-Air, Amana, Inglis, and Magic Chef dryers. If your dryer isn’t advancing through cycles or stops unexpectedly, replacing the timer may solve the issue. Made from durable materials, this part ensures reliable performance and longevity.