110C60222511 Kenmore Dryer - Instructions

I inserted the sharp kniife point, pryed back a flap , thus releasing the nylon locking hook, in the slot. then did the other side...I removed the white plastic handle, leaving the metal frame, which lay more flat in the filter channel. I put a box of screws on top of the dryer flap to keep it snug.. this is a Kenmore about 15 years old.
Grahare

received part 4 days after order. very pleased about that! Local Sears Service center was out of stock.

carefully removed old "handleless" lint filter.
inserted new lint filter and Voila! success.

Easily installed lint filter for my 25 yr old dryer Thanks

Pulled out the very old worn out and damaged filter screen and replaced it with a new filter screen.

Pretty much followed your great video: . Watching it gave me the confidence that I could accomplish the job myself.

replaced rollers, belt and pulley. Video was very helpful

Followed the instructions found online. Only thing I would add is that the clips are easier to work with if you warm them up a little before you try to install them.

Just slide out lint remover and inserted new one. Very easy

There were no repairs - I just ordered a lint screen because the screen on the last one pulled away from the frame and wasn't doing a good job of catching the lint. Took approximately 2 seconds to push the new one in the slot.

Fast efficient delivery from Parts Select.com.

No need to publish this I'm sure.

I thought I had checked the arm piece of the rack real good for a product number on my original part but I missed the number till the 2nd box came in, and a looked real careful and realized it was the same as the order I thought was bad.
Put the spring arm in first and the rack will fit in the front groove.
It would have been good if there had been a picture of the dryer arm attached to the dryer.
So I have 2 good racks and will return one if you tell me where to send it.
Keith Walden..

removed the old damaged filter and replaced with the new one

Opened the cabinet and removed the drum. Cleaned out the dryer fuzz. found that the roller stabilizer wasn't in place; apparently due to a previous repair. Replace both rollers and the roller stabilizer and prepared to replace the drum. But because I live alone, I didn't have anyone to hold the drum while I connected the belt to the motor. But, I did have three unused balloons which I partially inflated and set the drum on them in the bottom of the cabinet while I hooked up the belt to the motor. Put everything back together and it is now drying my clothes again. :)

Watched the video, followed the printed instructions for reminder when necessary. Needed a second person briefly to hold the dryer tub when installing the new belt, and also when removing/replacing the front panel. Beyond that, it was straight forward and relataively easy to do. Solved the noise problems and it dries more evenly now as well. The one thing the instructions don't say is to check the rear canvas seal when the tub is re-inserted into place to assure it doesn't fold back on itself.

Removed old filter and replaced with the new one.

flipped up the top pulled the front off easy access to drum removed the drum replaced rollers per instructions that came with package. very eas job. works great.