11086471 Kenmore Dryer - Parts

This screw is sold individually.

Metallic screw that is less than an inch long. Does not include the plastic washer.

If your dryer isn’t heating properly, this adjustable thermostat kit could be the solution. It helps keep the dryer at the right temperature by turning the heat on and off as needed. You can set it anywhere between 135°F and 155°F, and it kicks the heat back on when the temperature drops by 20°F. The kit comes with everything you need—the...Read morermostat, jumper wires, and wire nuts—and is a great fix for dryers that aren’t warming up like they should.

This seal kit for large capacity gas and electric clothes dryers includes a seal, an adhesive, and an instructions sheet. This felt seal for the back of the drum is sewn with red thread.

Replace the shaft of your right side drum support roller with this part. This replacement shaft is 3-3/16 inches long, but does not require a washer or a nut.

This includes the switch, brackets and hardware.

This part is the replacement single front panel clip for your dryer. It is made of metal and is approximately 2 inches long and ¾ inch wide. The front panel retainer clip is what holds the front panel on to the dryer. If the clip is damaged or missing, or if the front panel appears loose, you may need to replace the clip. This part is sold individually and is an authentic OEM part.

Also known as the inside sleeve for the knob to be able to properly fit over the shaft of the switch. Sold individually.

Sold Individually.

This part is used to secure the top panel to the cabinet. Sold individually.

Also known as a Moisture Sensor.

This front bearing and seal kit comes with the adhesive.