11081375310 Kenmore Washer - Parts
Enter a part description. DIY Heroes keep it simple, eg. "belt" or "pump".
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Lid Switch
Part #W10820036
Keep your washer or dryer running safely with this easy-to-install lid or door switch kit. It stops the machine from working when the door is open, helping prevent spills and accidents. Compatible with many models, this small but important part fits neatly inside your appliance and comes with everything you need for installation. Just unp...Read morelug your machine, swap out the old switch, and you're good to go. It’s about 2.5 inches long and blends in with most interiors.
Read less
Washer Hose Clamp
Part #WP596669
Drive Block - 2 5/16 Inch High
Part #WP389140
If your washer is noisy, shaking, or leaving clothes wet, the drive block might need replacing. This part connects the basket to the drive shaft so it can spin properly during cycles. It’s built for large-capacity washers and measures about 2-5/16 inches high. Swapping it out is straightforward with basic tools—just make sure the washer i...Read mores unplugged and water is turned off before you start. A quick fix for smooth, efficient washing again.
Read less
Suspension Pads - Package of 3
Part #285219
This is a pack of three suspension pads for your washer. The suspension pads in your washer are found underneath the tub and prevent the rotating metal parts from grinding on one another. If your suspension pads are worn out, you will likely hear metal-on-metal grinding, which is an indication they need to be replaced. It is recommended to replace all three suspension pads at the same time.
Idler Shaft Retaining Ring
Part #WP354987
This idler shaft retaining ring is well under an inch long and is made of metal.
Inner Tub Filter Plug Kit
Part #285868
Kit contains 4 plugs - replaces the lint filter that goes under spin basket. The filter under the spin basket is no longer required. Replaces round filter assembly.
Clutch Lining Kit
Part #285790
This clutch band and lining kit helps control the washer's spin cycle by regulating the transfer of power between the drive system and the wash basket. It allows the basket to gradually reach full spin speed, helping remove excess water from clothing at the end of the cycle. If the washer is spinning slowly, leaving clothes wet, making un...Read moreusual noises, vibrating excessively, or not spinning at all, a worn clutch may be the cause. Replacing the clutch components with this kit can help restore proper spin performance, improve water extraction, and keep the washer operating efficiently. The kit includes the key parts needed to repair the clutch assembly and restore reliable operation.
Read less