110760 Kenmore - Parts
Enter a part description. DIY Heroes keep it simple, eg. "belt" or "pump".
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Dryer Drum Roller Shaft Left Side
Part #WPW10359270
Replace the shaft of your left side drum support roller with this part from Whirlpool/Kenmore. This replacement shaft is 2-7/8 inches long. It is meant for use with many of Whirlpool/Kenmore's gas and electric clothes dryers that have been manufactured since 1965. Also known as Drum Roller Shaft.
Dryer Thermal Cutoff
Part #WP8573713
The thermal cut off fuse will disrupt the power flow to the drive motor when the dryer gets too hot. If your dryer will not heat properly, or will not heat at all the issue could be with a faulty or damaged thermal cut off fuse. Before you replace the faulty cut off fuse, make sure you disconnect the power from your dryer.
Liquid Propane Conversion Kit
Part #49572A
This gas dryer conversion kit allows a dryer that is set up for natural gas to be converted for use with liquid propane (LP) gas. The kit includes the key components needed for the conversion, including burner orifices, a regulator vent cap, and a conversion decal. You may need this kit when installing a dryer in a location that uses LP g...Read moreas instead of natural gas. Using the correct conversion kit helps ensure proper gas flow, reliable heating performance, and safe dryer operation after the conversion is completed.
Read less
Drive Motor with Threaded Shaft - 120V 60Hz
Part #279787
The blower shaft is 1-5/8 inches long, while the drive shaft is 1-1/4 inches long.
Side and Bottom Vent Kit
Part #W10470674
This kit is used for the bottom and side exhaust. The kit includes both the straight and elbow vent.
Screw
Part #WP488729
Metallic screw that is less than an inch long. Does not include the plastic washer.
Washer D-Shaped Knob Insert
Part #WP8536939
This insert is sold individually. Knob not included. Knob is sold separately.
Thermal Cut-Off Fuse Kit
Part #W11050897
Dryer Drum Support Roller Shaft Right Side
Part #WPW10359269
Replace the shaft of your right side drum support roller with this part. This replacement shaft is 3-3/16 inches long, but does not require a washer or a nut.
Single Front Panel Cip
Part #W10854425
This part is the replacement single front panel clip for your dryer. It is made of metal and is approximately 2 inches long and ¾ inch wide. The front panel retainer clip is what holds the front panel on to the dryer. If the clip is damaged or missing, or if the front panel appears loose, you may need to replace the clip. This part is sold individually and is an authentic OEM part.