11074413 Kenmore Washer - Parts

The valve body of this part could be blue or green in color. There are two ports for water to enter, and this valve is compatible with a half inch ID hose. It has two 3/4-11x1/2 NHT hose threads.

This kit contains one screw with rubber gasket and threaded sealant. The screw head is 7/16".

This main outer tub seal is a critical component that prevents water from leaking at the bottom of the tub during operation. Measuring approximately 2 inches in diameter, it is constructed from durable black plastic for long-lasting performance. Proper installation requires disconnecting power, drain hose, and inlet hose, followed by remo...Read moreving the outer cabinet and the entire tub assembly. Inspect the seal for cracks or wear during maintenance to avoid leaks and ensure optimal washer performance.

Keep your washer or dryer running safely with this easy-to-install lid or door switch kit. It stops the machine from working when the door is open, helping prevent spills and accidents. Compatible with many models, this small but important part fits neatly inside your appliance and comes with everything you need for installation. Just unp...Read morelug your machine, swap out the old switch, and you're good to go. It’s about 2.5 inches long and blends in with most interiors.

This hose clamp is sold individually.

Sold individually.

This hose can handle hot or cold water and is five feet long.

This screw is sold individually.

This part gets the motor up to speed quickly before transferring power to the run capacitor.

Note: This part has been updated by the manufacturer. It may appear different but will still function the same as the original.

This clamp helps to prevent leaking by holding the end of water hose in place.