1107314613 Kenmore Washer - Parts

This main outer tub seal is a critical component that prevents water from leaking at the bottom of the tub during operation. Measuring approximately 2 inches in diameter, it is constructed from durable black plastic for long-lasting performance. Proper installation requires disconnecting power, drain hose, and inlet hose, followed by remo...Read moreving the outer cabinet and the entire tub assembly. Inspect the seal for cracks or wear during maintenance to avoid leaks and ensure optimal washer performance.

Keep your washer or dryer running safely with this easy-to-install lid or door switch kit. It stops the machine from working when the door is open, helping prevent spills and accidents. Compatible with many models, this small but important part fits neatly inside your appliance and comes with everything you need for installation. Just unp...Read morelug your machine, swap out the old switch, and you're good to go. It’s about 2.5 inches long and blends in with most interiors.

This hose clamp extends from half an inch to an inch in diameter. It is made entirely of metal and is intended for use with Maytag brand washing machines.

This hose clamp is sold individually.

Sold individually.

This hose can handle hot or cold water and is five feet long.

This screw is a little under an inch long and is made of metal. It is used with a refrigerator's ice maker assembly. Sold individually.

Sold individually. NOTE: The color on the screw may not be the same as the image, but will still function the same.

This gray and white washer lid bumper contains a rubber bottom and is sold individually.

Note: This part has been updated by the manufacturer. It may appear different but will still function the same as the original.

This clamp helps to prevent leaking by holding the end of water hose in place.

If your washer is noisy or shaking, the spanner nut might need replacing. This part locks the inner tub to the drive block so it spins smoothly during cycles. It has a right-hand thread and is easy to install with basic tools—just make sure the washer is unplugged and water is turned off before you start. A simple fix for a quieter, more efficient wash.