11072046 Kenmore Washer - Instructions
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Washer quit running when lid was closed
-
Colleen from Indianapolis, IN
- A Bit Difficult
- 1- 2 hours
-
Screw drivers, Socket set
This repair took me longer because I was just giving it a try - I have no experience, although I tend to be "handy." I'm sure anyone with experience would rate this as "easy" and have taken only a short time. I had to watch the video several times to understand what to do - and the comments were helpful too. My washer is an OLD maytag,
... Read more
so I removed the front of the dash and pulled it forward to access the electronics. My switch had only 2 prongs, so I hooked up to the "lid closed" option on the new switch. It works perfectly now. Very pleased I gave it a try.
Read less
Was this helpful?
Thank you for voting!
Had issues with removing the inner tub
-
Bruce from Yankton, SD
- A Bit Difficult
- 1- 2 hours
-
Pliers, Screw drivers, Socket set
Had a lot of corrosion on the shaft area and had a hard time removing the inner tub but after some WD-40 and unprintable words and labor it popped off. Cleaned everything up, shaft, inner drum and outer drum. After that everything was a piece of cake. Thanks for the help!
Was this helpful?
Thank you for voting!