1106518401 Kenmore Dryer - Parts

This kit contains two door strikes, and three door catches to service dryer doors that have one or two catches.

This black actuator spring with white rubber tip is used for both dryer doors and washer lids.

Keep your washer or dryer running safely with this easy-to-install lid or door switch kit. It stops the machine from working when the door is open, helping prevent spills and accidents. Compatible with many models, this small but important part fits neatly inside your appliance and comes with everything you need for installation. Just unp...Read morelug your machine, swap out the old switch, and you're good to go. It’s about 2.5 inches long and blends in with most interiors.

This screw is sold individually.

If your dryer isn’t heating properly, this adjustable thermostat kit could be the solution. It helps keep the dryer at the right temperature by turning the heat on and off as needed. You can set it anywhere between 135°F and 155°F, and it kicks the heat back on when the temperature drops by 20°F. The kit comes with everything you need—the...Read morermostat, jumper wires, and wire nuts—and is a great fix for dryers that aren’t warming up like they should.

This part is the replacement single front panel clip for your dryer. It is made of metal and is approximately 2 inches long and ¾ inch wide. The front panel retainer clip is what holds the front panel on to the dryer. If the clip is damaged or missing, or if the front panel appears loose, you may need to replace the clip. This part is sold individually and is an authentic OEM part.

This part is used to secure the top panel to the cabinet. Sold individually.

This front bearing and seal kit comes with the adhesive.

This clamp is used to secure the drive motor.

Sold individually.

This screw is sold individually.

Fits around the front of the drum.