11062044 Kenmore Washer - Parts

This main outer tub seal is a critical component that prevents water from leaking at the bottom of the tub during operation. Measuring approximately 2 inches in diameter, it is constructed from durable black plastic for long-lasting performance. Proper installation requires disconnecting power, drain hose, and inlet hose, followed by remo...Read moreving the outer cabinet and the entire tub assembly. Inspect the seal for cracks or wear during maintenance to avoid leaks and ensure optimal washer performance.

This black actuator spring with white rubber tip is used for both dryer doors and washer lids.

Keep your washer or dryer running safely with this easy-to-install lid or door switch kit. It stops the machine from working when the door is open, helping prevent spills and accidents. Compatible with many models, this small but important part fits neatly inside your appliance and comes with everything you need for installation. Just unp...Read morelug your machine, swap out the old switch, and you're good to go. It’s about 2.5 inches long and blends in with most interiors.

This appliance hose clamp holds a hose firmly against its connection to help prevent leaks and keep it from slipping loose during operation. It applies pressure around the hose where it joins a pump port or other fitting. A bent, broken, corroded, or weakened clamp may allow water to drip from the connection or the hose to detach. Replaci...Read moreng a damaged clamp helps restore a secure connection. Disconnect power and shut off the water supply before servicing, then check for leaks after reassembly. This is an OEM part sourced directly from the manufacturer.

This hose clamp is sold individually.

Sold individually.

This screw is sold individually.

This screw is a little under an inch long and is made of metal. It is used with a refrigerator's ice maker assembly. Sold individually.

Sold individually. NOTE: The color on the screw may not be the same as the image, but will still function the same.

This gray and white washer lid bumper contains a rubber bottom and is sold individually.

This clamp helps to prevent leaking by holding the end of water hose in place.

If your washer is noisy or shaking, the spanner nut might need replacing. This part locks the inner tub to the drive block so it spins smoothly during cycles. It has a right-hand thread and is easy to install with basic tools—just make sure the washer is unplugged and water is turned off before you start. A simple fix for a quieter, more efficient wash.