110607 Kenmore Dryer - Parts

This is a replacement bearing ring kit for your dryer. The bearing rings are found on the top and bottom lips of the dryer drum. If your dryer is unusually noisy, or the drum will not turn during operation, or if there are marks left on your clothes after a cycle, you may need to replace the bearing ring kit. The kit comes with 2 bearings...Read more, one for the top and one for the bottom of the dryer drum. Remove the front panel of your dryer to access the dryer drum for this repair. At this point you can use a pair of needle nose pliers to release the old bearing rings from the drum. Snap the new bearing rings on, and reassemble the dryer to complete your repair.

This is a 4-terminal switch.

This dryer motor pulley is a genuine OEM replacement part designed for select dryer models. It connects to the motor shaft and supports the drive belt, enabling smooth rotation of the drum during operation. A worn or damaged pulley can result in squealing, grinding noises, or inefficient drum movement. Replacing the pulley can restore pro...Read moreper function and reduce noise. Always verify your appliance’s model number before purchasing to ensure compatibility. Installation may require basic tools and safety precautions, including disconnecting power before beginning the repair.

Includes high temperature adhesive.

This seal comes with the adhesive backing.

This front panel seal kit doesn't include the plastic retainers, reuse the old retainers. No glue is needed, the seal stretches to fit.

Replace the shaft of your left side drum support roller with this part from Whirlpool/Kenmore. This replacement shaft is 2-7/8 inches long. It is meant for use with many of Whirlpool/Kenmore's gas and electric clothes dryers that have been manufactured since 1965. Also known as Drum Roller Shaft.

This screw is sold individually.

Metallic screw that is less than an inch long. Does not include the plastic washer.

Replace the shaft of your right side drum support roller with this part. This replacement shaft is 3-3/16 inches long, but does not require a washer or a nut.

This part is the replacement single front panel clip for your dryer. It is made of metal and is approximately 2 inches long and ¾ inch wide. The front panel retainer clip is what holds the front panel on to the dryer. If the clip is damaged or missing, or if the front panel appears loose, you may need to replace the clip. This part is sold individually and is an authentic OEM part.

Also known as the inside sleeve for the knob to be able to properly fit over the shaft of the switch. Sold individually.