11049 - Parts

This is the replacement bellow clamp for your washer. It approximately 16 inches in diameter and is sold individually. The bellow clamp goes around the bellow in your washer and holds it in place on the washer frame. The main reason you would want to replace the bellow clamp is if it is rusted or damaged, and it is not holding the bellow ...Read moreinto place. To remove the bellow clamp, simply use a screwdriver to pop the bellow clamp out of the groove it rests in. Place the new clamp back into the bellow groove until it snaps into place. This is an OEM part from the manufacturer.

This hose goes from the drain pump to the back of the washer.

This hose attaches to water pump assembly. NOTE: As per the manufacture if the washer has an Eco Ball, it's no longer needed when the new hose is installed.

Sold individually.

This door lock/latch assembly is an OEM replacement part for front-load washing machines. It secures the door during operation, preventing leaks and ensuring the washer functions correctly. A faulty door lock may cause issues such as the washer failing to start, stopping mid-cycle, or preventing the door from opening.

This is an actuator switch to trigger bleach, detergent, or fabric softener housings to be dispensed into the tub of your washing machine. If your detergent cups are not dispensing, you may need to replace this part. The part is made of off-white plastic and metal.

This drive pulley attaches to the back of the washers drum.

This hose clamp is sold individually.

This part attaches to the door and fits into the door lock when the door closes.

This idler shaft retaining ring is well under an inch long and is made of metal.

This water level switch senses the level of water in the inner tub.