11042926203 Kenmore Washer - Parts

This part is also called the Door Boot Seal. It's the main seal between the front bulkhead and the outer tub. Clamps are not included. NOTE: Must order clamps separately, if needed.

This part helps keep your front-load washer safe and working properly. It locks the door during cycles so it doesn’t open unexpectedly, and it also tells the washer when the door is shut so it can start. If your washer won’t start or the door won’t lock or open, this part might be the fix. It’s made to fit many models and includes a four-lead switch for reliable performance. Just unplug the washer before installing.

If your washer isn’t draining properly or is leaking water, this drain pump could be the fix. It’s made for front-load models from Whirlpool, Maytag, Kenmore, and more. The pump helps remove water during the wash cycle and keeps your machine running smoothly. Common signs it needs replacing include loud noises, drainage errors, or water left in the drum. Just check your model number to make sure it’s the right fit.

This 18 ml bottle of white appliance touch-up paint is used to cover scratches or marks on your appliance. The white touch-up paint can be used on refrigerators, microwaves, ranges, clothes dryers, and freezers. This is a genuine OEM part and includes a brush applicator. Please remember to wear gloves to protect your hands when applying this paint.

Used with some front load washers. The attaching solenoids on the valve open and close according to the desired temperature, or amount of water needed.

Shock absorbers help keep the washer from vigorous shaking during its cycles. Sold individually.

This part continually measures the amount of water entering the tub. It will make adjustments if too much or too little water is present.

This part regulates the temperature of the water in the tub. The sensor is located in the heating element.

This drive belt is made to slip on the motor pulley to bring the basket up to the speed required and this makes the belt get wear and tear. NOTE: Per Manufacture, belt measures 48.22" long uninstalled and the belt will stretch To 51.53" when installed.

Used to help hold your bellow in place on your washer.

This is the replacement bellow clamp for your washer. It approximately 16 inches in diameter and is sold individually. The bellow clamp goes around the bellow in your washer and holds it in place on the washer frame. The main reason you would want to replace the bellow clamp is if it is rusted or damaged, and it is not holding the bellow ...Read moreinto place. To remove the bellow clamp, simply use a screwdriver to pop the bellow clamp out of the groove it rests in. Place the new clamp back into the bellow groove until it snaps into place. This is an OEM part from the manufacturer.

This hose goes from the drain pump to the back of the washer.