1069700 Kenmore - Parts

Sold individually.

This icemaker water inlet cup is three inches long. It is all white in color and is made of plastic.

The evaporator is found in the back of the freezer. This kit comes with two mounting grommets, two sleeves (not to be used on porcelain models), two #8 mounting screws, and a push-on fan blade. NOTE: NO LONGER ABLE TO GET BRACKETS. SEE PART INSTRUCTIONS IN SERVICE MATTERS INSTRUCT SHEET# W11500157 11/20KC.

This door shelf end cap set contains two white end caps and adhesive tape.

16ml

This part is also known as the cycling thermostat and this bi-metal device controls the activation of the icemaker ejection cycle.

The water inlet valve is a solenoid-operated switch located at the bottom of the refrigerator. When it is energized by electrical power, water is released from the supply line through the water valve and into the compact icemaker mold. ***Please NOTE: This part has been redesigned and may appear different than the original. It has a new...Read more quick connection. To install: cut the retaining nut off the existing water line and gently push into new valve. To remove: depress the ring that the tube slides into.

This screw is sold individually.

Metallic screw that is less than an inch long. Does not include the plastic washer.

This is a 6 piece kit.

This part controls the light.

This part can be used on either side of the center door hinges for some refrigerators.