1069651721 Kenmore Refrigerator - Parts

This part is the replacement end cap trim for your refrigerator. It is made of white plastic and is approximately 1 inch wide, 1 inch long, and ½ inch thick. This part can also be known as the shelf support retainer as it holds the shelf support in place. If the end cap trim is damaged, the shelf support may not remain in place and you wi...Read morell not be able to store items in your refrigerator door. To replace the end cap trim, carefully disconnect it from both the refrigerator door and the shelf support. Then, snap the new end cap trim into the shelf support and then to the door. This part is sold individually and is an authentic OEM part.

This part may come in white or clear plastic, but either will still work and fit properly in your appliance.

This compression nut is used with the plastic water line of the icemaker assembly.

The cabinet base roller axle is held in place on the cabinet by this axle and clip kit. It is an OEM part for select refrigerators and freezers. Check fit against your appliance model number.

The bulb is sold separately.

This part may be too long for your appliance and may need to be cut to fit your specific dimensions.

Sold individually.

This part strips ice from the icemaker mold during the ejection cycle to prevent ice pieces from falling back into the mold.

This part may be longer than the original - it might need to be cut to the correct size for your appliance.