1069630 Kenmore Refrigerator - Parts

This device acts like a clock. It continually advances and alternates between activating the cooling cycle and the defrost heater.

This is the replacement evaporator drip tray for your refrigerator. It is made of white plastic and is approximately 19 inches by 9 inches. The evaporator drip tray sits below the evaporator to collect dripping water. If the drip tray is damaged, you may notice that your refrigerator is leaking. Because it is made of plastic, the drip tra...Read morey can eventually develop a crack. You will need to pull out the refrigerator from the wall, and take off the bottom panel on the back of your refrigerator in order to access the drip tray for replacement. This is an OEM part sourced directly from the manufacturer.

Sold individually.

This is the replacement water tube kit for your refrigerator. This tubing is made of plastic, is 1/4 inch in diameter, and comes with 2 inserts. This tube may be longer than the original tube, and may need to be cut. This water tube transports water to the ice and water dispensers. If your refrigerator is leaking, or if the ice and water ...Read moredispensers are not dispensing properly, you may need to replace this tube. This part is sold individually and is an OEM part sourced directly from the manufacturer.

Sold individually.

This fourteen cube ice cube tray is eleven inches long. It is all white in color and is made entirely of plastic.

Start relay and overload for production compressor only. The start relay boosts the compressor, and then shuts off as soon as the motor gets up to speed. The overlay provides added protection against excessive current and against excessive temperature use.

The overload protects a motor from overheating and the relay boosts the compressor.

This ice cube mold and heater assembly has a flake resistant surface. It is used with modular style icemakers on some refrigerators.

Sold individually.

This compression nut is used with the plastic water line of the icemaker assembly.