1069600 Kenmore Refrigerator - Parts

This icemaker kit comes with a flat plug, wiring harness, fill tube, water inlet valve, ice bin, mounting hardware, and instructions.

This screw is sold individually.

Metallic screw that is less than an inch long. Does not include the plastic washer.

This is a 6 piece kit.

This part controls the light.

This part can be used on either side of the center door hinges for some refrigerators.

Substituted with part number PS869887.

This is the replacement evaporator drip tray for your refrigerator. It is made of white plastic and is approximately 19 inches by 9 inches. The evaporator drip tray sits below the evaporator to collect dripping water. If the drip tray is damaged, you may notice that your refrigerator is leaking. Because it is made of plastic, the drip tra...Read morey can eventually develop a crack. You will need to pull out the refrigerator from the wall, and take off the bottom panel on the back of your refrigerator in order to access the drip tray for replacement. This is an OEM part sourced directly from the manufacturer.

Sold individually.

This fourteen cube ice cube tray is eleven inches long. It is all white in color and is made entirely of plastic.

Start relay and overload for production compressor only. The start relay boosts the compressor, and then shuts off as soon as the motor gets up to speed. The overlay provides added protection against excessive current and against excessive temperature use.

The overload protects a motor from overheating and the relay boosts the compressor.