1069557913 Kenmore Refrigerator - Parts

Also known as Alumilastic Cement.

If your refrigerator’s ice dispenser won’t switch between crushed and cubed, the solenoid may be the part to check. It shifts the ice container deflector to select the dispensing type. This OEM replacement requires partial refrigerator disassembly and basic hand tools; a multi-screwdriver is listed. Disconnect power by unplugging the refr...Read moreigerator or switching off its circuit breaker before installation. Confirm fit using your refrigerator’s model number.

This door hinge comes with screws. Sold individually.

This ice auger support, also known as a baffle, is a manufacturer-approved replacement part for your refrigerator ice maker. This part can become cracked or damaged, preventing your ice auger from doing its job. This repair requires extensive disassembly; take photos as you go to make reassembly easier. To replace this part, life the ice ...Read moredoor out of the way and life the ice arm into the off position. Pull out the ice bucket and use a 1/4 inch nut driver to remove the screws holding the ice container and connecting rod in place. Pry the e-clip and washer off the bottom of the auger assembly. Use a 9/16ths wrench to remove the nut at the bottom of the auger. Pull off the auger teeth assembly and replace the auger support with your new part. Now you can begin reassembling.

This part helps protect the motor from overheating. The relay is sold separately.

For dispensing, ice is stored in this OEM container in the refrigerator freezer. Auger parts are not included. Unplug the appliance before installing it and follow the owner's manual.

This bracket is used in conjunction with the ice maker.

These inserts are used with 1/4 inch plastic tubing.

Sold individually.