1069512 Kenmore Refrigerator - Parts

This screw is sold individually. Size: 8-32 x 1/4 inch.

Sold individually. The size of this screw is 1/4" hex head and 10-12 x 1/2".

This part turns the light on/off as the door opens and closes.

This part consists of a cube and arm that upon activation opens the ice container gate and allows the ice cubes to enter into the chute and into the ice and water dispenser.

Also known as Alumilastic Cement.

This part helps to slide the drawer in and out. It mounts to the inside wall of your refrigerator.

This part helps to slide the drawer in and out. It mounts to the inside wall of your refrigerator.

This cold control thermostat has a temperature range from 36 degrees Fahrenheit to 17 degrees Fahrenheit and a capillary length of 26 inches.

This air diffuser controls the amount of cold air distributed through the refrigerator.

This motor rotates the auger. When the auger rotates, it pushes ice out of the bin, through a chute to the user.

This ice auger support, also known as a baffle, is a manufacturer-approved replacement part for your refrigerator ice maker. This part can become cracked or damaged, preventing your ice auger from doing its job. This repair requires extensive disassembly; take photos as you go to make reassembly easier. To replace this part, life the ice ...Read moredoor out of the way and life the ice arm into the off position. Pull out the ice bucket and use a 1/4 inch nut driver to remove the screws holding the ice container and connecting rod in place. Pry the e-clip and washer off the bottom of the auger assembly. Use a 9/16ths wrench to remove the nut at the bottom of the auger. Pull off the auger teeth assembly and replace the auger support with your new part. Now you can begin reassembling.